Instructions / Assembly

Installation Instructions Installation Instructions
Questions: Call 800-234-4228 Questions: Call 800-234-4228
2-Panel Patio Door
with Non-Assembled Frame
2-Panel Patio Door
with Non-Assembled Frame
8 9
Transparency to
create outlines
Transparency to
create outlines
Step 12
Step 11
Apply two 1/4" beads
of sealant to sill and 2"
up each side of rough
opening.
Silver Line strongly recommends that you use a membrane or
vinyl-based sill pan to ensure a weathertight seal. Follow the sill pan
manufacturer’s installation instructions.
Apply sealant and
fasten jambs to
sill and head.
Apply sealant over foam
gasket on jamb where it
will contact the sill.
1
Replacement: For Non-Nailing Fin Applications Only
2"
2"
2"
Step 10
Apply interior and
exterior trim.
Caulk the perimeter of
interior and exterior for
a weathertight seal.
Then proceed to either Step
16 if you want to switch
orientation of operating
panel or to Step 20 to nish
installation.
Exterior
Interior
Step 9
Apply self-adhesive
ashing to cover the
nailing n.
Apply to the sides rst and
ensure it extends beyond the
top of the door. Then apply to
the top, extending beyond the
sides.
Exterior
IMPORTANT – To create a weathertight seal, ensure that the ash-
ing fully covers the entire length of the jambs and head of the door
around the door opening. Pay special attention to the corners to
ensure that there are no gaps in the ashing.
Fasten with 3,
#8x2"athead
screws (included)
in each location
using pre-drillled
holes.
2
3
Repeat in other
3 corners. Make
sure tracks line
up.