Instructions / Assembly

Installation Instructions Installation Instructions
Questions: Call 800-234-4228 Questions: Call 800-234-4228
2-Panel Patio Door
with Non-Assembled Frame
2-Panel Patio Door
with Non-Assembled Frame
14 15
Transparency to
create outlines
Transparency to
create outlines
Place turn lever into bottom,
larger hole on interior of
moving panel.
After door panel rollers are adjusted,
installthe3/4"screwsthroughthe
slots on the keeper nger tight to
allow for adjustments. Close moving
panel to check position. When door
locks correctly, secure the keeper in
placeusingtwo,2"screwsthrough
the holes in the keeper.
Adjust as necessary for
smooth operation. Tighten
screws.
Step 22
Step 24
Step 23
Install handle and lockset on
moving panel.
Install keeper on jamb.
1
1
2
2
Fasten with 2 long screws
included with handles.
3
Turn Lever
Interior
Handle
Exterior
Handle
Adjust moving
panel rollers.
Lift door panel slightly to
minimize weight on rollers.
Turn lower screws to adjust
rollers so that door panel is
plumb with frame and door
slides smoothly.
Lower Rollers
Raise Rollers
Place larger interior handle and
smaller exterior handle onto
door with grips toward glass.
NOTE: Optional keyed handle
set should be installed so key
is on exterior.
Raise rollers
Lower rollers
A.
B.
Raise rollers
Lower rollers
A.
B.
Raise rollers
Lower rollers
A.
B.
Interior
Step 21
Install moving panel
from the exterior.
Place top of moving panel into
interior track, then gently set
bottom of panel in place in the
interior track.
NOTE: Be sure that the
weatherstripping on the vertical
interlock faces the exterior.
Exterior
Interior
Weatherstripping