ADC ® 2200 AdvantageTM Fingertip Pulse Oximieter Directions for Use ®
ADC® Fingertip Pulse Oximeter Thank you for purchasing an ADC ADvantage™ Fingertip Pulse Oximeter. We’re proud of the care and quality that goes into the manufacture of every product that bears our name. The ultra-portable Advantage™ 2200 will give you information about oxygen saturation (the amount of oxygen in the blood) and pulse rate at your fingertip. The 2200 is easy to use and needs no routine maintenance except battery replacement.
prescribed by your doctor. CAUTION: Excessive movement of the Advantage™ 2200 during measurement may cause inaccurate readings. Limit finger movement as much as possible when using the device. CAUTION: The Advantage™ 2200 is not intended for continuous monitoring. CAUTION: Do not place the Advantage™ 2200 on the same hand/arm when using a blood pressure monitor. CAUTION: The Advantage™ 2200 has NO alarms.
(Figure 1) Note: • Battery polarity should be observed to prevent damage to the device. • When battery is low, the battery indicator symbol on the display will flash. Replace low battery as soon as possible. Remove battery if the device will not be used for more than 30 days. Strap Installation (figure 2) 1. Thread thinner end of the strap through the loop. 2. Thread thicker end of the strap through the threaded end before pulling it tightly. (Figure 2) 1. 2. Operation Instructions (figure 3) 1.
Reading Your Results After measurement begins, you will see three pieces of information displayed on your pulse oximeter: • A pulse bar graph display corresponding with your pulse beat will be shown. The height of Pulse Rate the bar graph shows your pulse strength. • Your pulse rate will be displayed as BPM or Oxygen beats per minute. Saturation • The amount of oxygen in your blood will be Power Button displayed as SpO2%.
Troubleshooting Problem SpO2 or pulse rate cannot be shown normally Solution Possible Reason 1. Re-insert/re-position finger 1. Finger is not inserted correctly. 2. Oxyhemoglobin value is too low to 2. Ensure that sensor is clean and not blocked be measured 3. Try taking a reading on a different finger or warm your finger by rubbing. SpO2 or pulse rateis shown unsta- 1. Finger might not be inserted deep 1. Re-insert/re-position finger. 2. Sit calmly and retry. bly enough. 2. Excessive patient movement. 1.
Some states do not allow the exclusion or limitation of incidental, special, or consequential damages, so this limitation may not apply to you. To Obtain Warranty Service: Send item(s) postage paid to ADC®, Attn: Repair Dept., 55 Commerce Dr., Hauppauge, NY 11788. Please include your name and address, phone no., proof of purchase, and a brief note explaining the problem.