Manual

Warnings and Precautions

Warning - A warning statement in this manual identifies a condition or practice which, if not

corrected or discontinued immediately could lead to patient injury, illness, or death.

Warning - If luer lock connectors are used in the construction of tubing, there is a possibility

that they might be inadvertently connected to intravascular fluid systems, allowing air to be

pumped into a blood vessel. Immediately consult a physician if this occurs.

Warning - Do not allow a blood pressure cuff to remain on patient for more than 10 minutes

when inflated above 10mmHg. This may cause patient distress, disturb blood circulation, and

contribute to injury of peripheral nerves.

Warning - Safety and effectiveness with neonate cuff sizes 1 through 5 is not established.

Warning - For all blood pressure systems that can be wall mounted, ensure that the unit is

securely mounted prior to use to avoid damage to the instrument and potential patient injury.

Warning - Do not use the 9002 in an explosive environment such as where flammable anesthet-

ics exist or inside an oxygen chamber with strong electrostatic and electromagnetic fields e.g.,

mobile phones.

Warning - Use of this instrument on patients under dialysis therapy or on anticoagulant,

antiplatelets, or steroids could cause internal bleeding.

Warning - Do not use cuffs, AC adapters or batteries other than those included with this product

or replacement parts supplied by the manufacturer.

Warning - This system may fail to yield specified measurement accuracy if operated or stored in

temperature or humidity conditions outside the limits stated in the specifications section of this

manual.

Caution - Federal law restricts this device to sale by or on the order of a physician or licensed

healthcare practitioner.

Caution - To avoid any possibility of accidental strangulation, keep this unit away from children

and do not drape tubing around your neck.

Note - To obtain the greatest accuracy from your blood pressure instrument, it is recommended

that the instrument be used within a temperature range of 50°F (10°C) to 104°F (40°C), with a

relative humidity range of 15-90% (non-condensing).

Note - All connectors and inflation system should remain connected to the device during storage

to avoid dust entering through the connector port.

ADC Item Item no.

1 Center Pole Screw (1) Washer (1) 972-101

2 Base 972-080

3 Casters (5) 972-106

3A Single Caster 972-106-1

4 Outer Pole 972-107

5 Knob 972-108

Mobile Base Assembly Parts

ADC Item Item no.

6 Spring 972-109

6A Gasket, Rubber 972-107A

7 Inner Pole 972-110

8 Basket Tightening Key 972-111

9 Basket 972-112

9B Manometer Mounting Hardware 752-114