User Manual

ADJ Products, LLC - www.adj.com - PinPoint GO User Manual Page 6
PinPoint GO Operating Instructions
Energy Saving Mode:
There are 2 ways you can set the PinPoint GO into energy saving
mode. When the PinPoint GO is set into energy saving mode, it will
decrease the LED brightness gradually when the battery life is less
than 80% to extend the battery life. NOTE: When the unit is using
DC power, the energy saving mode cannot be used.
1. Press the MODE button for 5 seconds to switch between normal
mode and energy saving mode. When the white LED flashes 3 times,
the PinPoint GO is in normal mode. When the white LED flashes for 5
seconds the PinPoint GO is in energy saving mode.
2. Using the ADJ LED RC3, press the BLACKOUT button for 5 sec-
onds to switch between normal mode and energy saving mode. When
the white LED flashes 3 times, the PinPoint GO is in normal mode.
When the white LED flashes for 5 seconds the PinPoint GO is in ener-
gy saving mode.
Low Battery Warning:
When the battery power gets below 30%, the LED will flash rapidly for
5 seconds each time the power is switched ON. After the 5 seconds,
the unit will function normally. This is a warning letting you know that
you must charge the unit soon.
Battery Recharge:
To recharge the battery, plug the supplied DC power supply into the
DC input located on the rear of the unit and plug the other end into a
matching power supply. It takes about 4.5 hours to reach full charge
with the power switch o.
Operating Power:
There are two ways to supply power to this unit; battery power or DC
power.
• DC Power - To run the unit using DC power, plug the unit into a DC
power source, and put the POWER switch into the ON position.
• Battery Power - To run the unit using Battery power, put the POWER
switch in the ON position.
Mode Button Lock:
The MODE button will lock itself after 30 seconds if nothing is
2.5 Do Not Expose the Battery to water or liquids
Never soak/drop the batteries in liquids such as water, seawater,
drinks such as soft drinks, juices, coee or other.
2.6 Battery Replacement
For battery replacement please contact ADJ customer support (800)
322-6337.
2.7 Do Not use a damaged Battery
The battery could be damaged during shipping, caused by shock.
Should the battery be found damaged, including damages to the
plastic casing of the battery, deformation of the battery package,
smelling of an electrolyte, or leakage of the electrolyte gel, or other,
DO NOT use the battery. A battery with a odor of electrolyte or a gel
leakage should be placed away from re to avoid re or explosion.
3. Battery Storage
When storing the battery, it should be stored at room temperature,
with a charge of at least 50%. We recommend that during long peri-
ods of storage that the battery be charged every 6 months. Doing
this will prolong the life of the battery and will also make sure that the
battery charge does not fall below the 30% mark.
4. Other Chemical Reaction
Because batteries utilize a chemical reaction, battery performance
will deteriorate over time even if stored for a long period of time
without being used. In addition, if the various usage conditions such
as charge, discharge, ambient temperature, etc. are not maintained
within the specied ranges, the life expectancy of the battery maybe
shortened or the device in which the battery is used may be damaged
by electrolyte gel leakage. If the batteries cannot maintain a charge
for long periods of time, even when they are charged correctly, this
may indicate it is time to change the battery.
5. Battery Disposal
Please dispose of battery according to local regulations.
PinPoint GO Battery Precautions
ADJ Products, LLC - www.adj.com - PinPoint GO User Manual Page 7