User Manual

PinPoint GO ADJ LED RC3 Remote
The ADJ LED RC3 infrared remote (Sold Separately) has many dif-
fernet functions and gives you complete control of your PinPoint GO.
To control the your desired fixture you must aim the controller at the
front of the fixture and be no more the 30 feet away.
BLACKOUT - Pressing this button will blackout the fixture. This but-
ton is also used to switch between normal mode and energy saving
mode. Please see Energy Saving Mode on the previous page.
AUTO RUN MODE - Press the AUTO RUN button to switch between
Fast Fade & Slow Fade. Press the SPEED button and use the “+” & “-”
buttons to adjust the fade speed. You can press the FLASH button
to activate strobing and use the “+” & “-” buttons to adjust the strobe
speed.
MANUAL MODE - Press the SELECT PROG button to activate CW
color. Use the “+” & “-” buttons to adjust the output intensity. Press
the FLASH button to activate strobing and use the “+” & “-” buttons
to adjust the strobe speed.
PinPoint GO Operating Instructions
pressed. To unlock the unit, press the MODE button for 3 sec-
onds.
Mode Operation:
Each press of the MODE button will cycle through the different oper-
ating modes. The operating modes are listed below in the order that
they appear. NOTE: When power is turned OFF and turned back
ON, the unit will start in the last operating mode.
Order of Operating Modes:
• 100% Brightness • 95% Brightness • 90% Brightness
• 84% Brightness • 78% Brightness • 72% Brightness
• 66% Brightness • 60% Brightness • 54% Brightness
• 48% Brightness • 42% Brightness • 36% Brightness
• 30% Brightness • 24% Brightness • 18% Brightness
• 12% Brightness • 6% Brightness • LED Off • Fast Fade • Slow
Fade
Pressing the MODE button again after Slow Fade will return the unit
to 100% brightness. Starting the operating mode order at the begin-
ning.
PinPoint GO Color Filter Install
The PinPoint GO comes with 4 color filters and 1 frost filter. To install
one of the filters carefully remove the retainer ring in front of the lens.
Install the filter and replace the retainer ring. Make sure the filter cut out
for the infrared receiver is in the correct place.
PinPoint GO Installation
The unit has two ways that it can be installed. The unit includes
a X-Clip so that it can be installed on drop down ceilings. Always
ensure that the unit is rmly xed to avoid vibration and slipping while
operating. Always ensure that the structure to which you are attach-
ing the unit is secure and is able to support a weight of 10 times the
unit’s weight. Always use a safety cable that can hold 12 times the
weight of the unit when doing this type of installation. The safety
cable should go through the eye hole nut that holds the X-Clip base in
place.
You can also install using the magantic base. To do this, remove the
X-Clip base by unscrewing the eye hole bolt. Once removed the x-
ture can be stuck to anything magnetic.
The equipment must be installed by a professional, and it must
be installed in a place where it is out of the reach of people’s
grasp.
ADJ Products, LLC - www.adj.com - PinPoint GO User Manual Page 8 ADJ Products, LLC - www.adj.com - PinPoint GO User Manual Page 9
PinPoint GO Photometric Chart