User Manual

Monster Beam System Menu
3. Press the UP or DOWN buttons to nd your desired show and
press ENTER to conrm. After pressing ENTER, press and hold
the MENU button for at least 3 seconds to activate.
Sound State - In this mode the unit will run in sound
active mode.
Note: If the unit is being run as a Stand Alone unit, it must
rst be set to Master under the Slave Mode.
1. Press the MENU button until “Sound State” is displayed, press
ENTER.
2. Either “On” or “Off” will now be displayed. Use the UP or
DOWN buttons to toggle between “On” and “Off”.
3. Press ENTER to conrm your selection, the press and hold the
MENU button to activate.
Sound Sense - In this mode you can adjust the sound
sensitivity of the sound active mode.
1. Press the MENU button until “Sound Sense” is displayed,
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (the lowest) and
100 (most sensitive).
3. Press ENTER to set you desired level.
DMX State - This mode can be used as a precaution
mode, that in case the DMX signal is lost, the operating
mode chosen in the setup is the running mode the xture will
go into when the DMX signal is lost. You can also set this as
the operating mode you would like the unit to return to when
power is applied.
1. Press the MENU button until “DMX State” is displayed, press
ADJ Products, LLC - www.adj.com - Monster Beam User Manual Page 9
Monster Beam System Menu
DMX Address - Set the DMX Address -
1. Press the MENU button until “DMX Addresss” is displayed,
press ENTER.
2. “X” will now be displayed, “X” represents the displayed address.
Press the UP or DOWN buttons to nd your desired address.
3. Press ENTER to conrm, and then press and hold the MENU
button for at least three seconds to assign.
Slave Mode - This will let you set unit as a master or
slave in a master/slave conguration.
Note: If the unit is being run as a Stand Alone unit, it must be
set to Master.
1. Press the MENU button until “Slave Mode” is displayed,
press ENTER. Either “Master”, “Slave 1”, or “Slave 2” will be
displayed.
2. Press the UP or DOWN buttons until your desired slave mode
is displayed, press ENTER to conm.
NOTE: In a Master/Slave conguration you can make one x-
ture the Master and then set the next xture to “Slave 2”, the
xtures will now have contrast movements to each other.
Show Mode - Show modes 0 - 12 (Factory Shows). Show
mode can run with or without sound active mode.
Note: If the unit is being run as a Stand Alone unit, it must
rst be set to Master under the Slave Mode.
1. Press the MENU button until “Show Mode” is displayed, press
ENTER.
2. “Show X” will now be displayed, “X” representing a number
between 0-12. Programs 1-12 are factory programs, while “Sh 0”
is random mode.
ADJ Products, LLC - www.adj.com - Monster Beam User Manual Page 8