User manual

ManualsBrandsAmerican DJ ManualsDJ EquipmentFlat Par QA5

User Instructions

WiFly Par QA5 Introduction

ADJ Products, LLC - www.adj.com - WiFly Par QA5 User Manual Page 2

4/13

Unpacking: Thank you for purchasing the WiFly Par QA5 by ADJ Prod-

ucts, LLC. Every WiFly Par QA5 has been thoroughly tested and has

been shipped in perfect operating condition. Carefully check the ship-

ping carton for damage that may have occurred during shipping. If the

carton appears to be damaged, carefully inspect your xture for any

damage and be sure all accessories necessary to operate the unit has

arrived intact. In the case damage has been found or parts are miss-

ing, please contact our toll free customer support number for further

instructions. Do not return this unit to your dealer without rst contact-

ing customer support.

Introduction: The WiFly Par QA5 is a rechargeable lithium battery

powered, DMX intelligent, LED par fixture with ADJ’s WiFly TransCeiver

with wireless DMX built-in. This unit give you the freedom to set up

your fixture where ever you wish without the restrictions of power or

DMX cabling. The built-in battery will keep charge for up to 6 hours (full

on) from a full, single charge. This xture can be used in a stand alone

mode or connected in a Master/Slave conguration. This wash has five

operating modes: Sound Active mode, Auto mode, RGB mode, Static

Color mode, and DMX control mode.

Customer Support: ADJ Products, LLC provides a customer support

line, to provide set up help and to answer any question should you

encounter problems during your set up or initial operation. You may

also visit us on the web at www.adj.com for any comments or sugges-

tions. Service Hours are Monday through Friday 8:00 a.m. to 4:30 p.m.

Pacic Standard Time.

Voice: (800) 322-6337

Fax: (323) 582-2941

E-mail: support@AmericanDJ.com

Warning! To prevent or reduce the risk of electrical shock or re, do

not expose this unit to rain or moisture.

Caution! There are no user serviceable parts inside this unit. Do not

attempt any repairs yourself, doing so will void your manufactures war-

ranty. In the unlikely event your unit may require service please contact

ADJ Products, LLC.

PLEASE recycle the shipping carton when ever possible.

WIFLY PAR QA5

Summary of content (16 pages)

PAGE 1
WiFly Par QA5 WIFLY PAR QA5 Introduction Unpacking: Thank you for purchasing the WiFly Par QA5 by ADJ Products, LLC. Every WiFly Par QA5 has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your fixture for any damage and be sure all accessories necessary to operate the unit has arrived intact.
PAGE 2
WiFly Par QA5 Features • • • • • • • • Rechargeable Lithium Battery Mulit-Colors Five Operating Modes Electronic Dimming 0-100% Built in Microphone DMX-512 protocol 3-Pin DMX Connection 8 DMX Channel Modes: 1 Channel Mode, 2 Channel Mode, 3 Channel Mode, 4 Channel Mode, 5 Channel Mode, 6 Channel Mode, 7 Channel Mode, & 8 Channel Mode • Built-In ADJ’s WiFly TransCeiver Wireless DMX • ADJ RFC compatiable (Not Included) • Power Cord Daisy Chain (See page 14) WiFly Par QA5 Warranty Registration The W
PAGE 3
WiFly Par QA5 Battery Precautions 1. Handling of Batteries 1.1 Do Not Short Circuit the Battery Try to never short circuit the battery. It generates a very high current which could cause the battery to overheat which may result in electrolyte gel leakage, harmful fumes, or explosion. The LIR tabs may easily short-circuit by placing them on conductive surface. A short circuit may lead to heat build up and damage of the battery.
PAGE 4
WiFly Par QA5 Battery Precautions life expectancy of the battery maybe shortened or the device in which the battery is used may be damaged by electrolyte gel leakage. If the batteries cannot maintain a charge for long periods of time, even when they are charged correctly, this may indicate it is time to change the battery. 6. Battery Disposal Please dispose of battery according to local regulations.
PAGE 5
WiFly Par QA5 Set Up POWER POWER Notice: Be sure to DMX512 follow figures two and three when making your own cables. Do not DMX+,DMX-,COMMON use the ground lug on the XLR connector. Do not connect the cable’s shield conductor to the ground lug or allow the shield conductor to come in contact with the XLR’s outer casing. Grounding the shield could cause a short circuit and erratic behavior.
PAGE 6
WiFly Par QA5 Operating Instructions as the ADJ Show Designer™. RGBA Dimmer Mode: 1. Plug the fixture in and press the MODE button until: 2. When “r.XXX” is displayed you are in Red dimming mode. Press the UP and DOWN buttons to adjust intensity. 3. When “G.XXX” is displayed you are in Green dimming mode. Press the UP and DOWN buttons to adjust intensity. 4. When “b.XXX” is displayed you are in Blue dimming mode. Press the UP and DOWN buttons to adjust intensity. 5. When “U.
PAGE 7
WiFly Par QA5 Operating Instructions sent the current DMX Channel Mode. 4. Use the UP or DOWN buttons to scroll through the DMX Channel modes. The Channel modes are listed below: To run the 1 Channel Mode, press the MODE button until “Ch01” is displayed. This is the 4 Channel DMX Mode. To run the 2 Channel Mode, press the MODE button until “Ch02” is displayed. This is the 2 Channel DMX Mode. To run the 3 Channel Mode, press the MODE button until “Ch03” is displayed. This is the 3 Channel DMX Mode.
PAGE 8
WiFly Par QA5 Master-Slave Configuration Master-Slave Configuration: This function will allows you to link units together to run in a Master-Slave mode. In Master-Slave operation one unit will act as the controlling unit and the others will react to the controlling units built-in programs. Any unit can act as a Master or as a Slave however, only one unit can be programmed to act as the “Master.” Master-Slave Connections and Settings: 1.
PAGE 9
WiFly Par QA5 ADJ RFC Operation The ADJ RFC remote (sold seperately) has many different functions and allows you to control your WiFly Par QA5 from long distance. The ADJ RFC remote can control your system up to 150 ft. To use the RFC you must first activate the fixtures receiver, to activate the receiver please see the instructions on page 14.
PAGE 10
WiFLY Par QA5 Channel 1 Value 0 - 255 2 0 - 255 3 0 - 255 4 0 - 255 WiFLY Par QA5 Channel 1 2 3 4 5 4 Channel - DMX Values & Functions Value 0 - 255 0 - 255 0 - 255 0 - 255 0 - 255 Function RED 0% - 100% GREEN 0% - 100% BLUE 0% - 100% AMBER 0% - 100% 5 Channel - DMX Values & Functions Function RED 0% - 100% GREEN 0% - 100% BLUE 0% - 100% AMBER 0% - 100% MASTER DIMMER 0% - 100% ADJ Products, LLC - www.adj.
PAGE 11
WiFLY Par QA5 Channel 1 2 3 4 5 6 Value 0 - 255 0 - 255 0 - 255 0 - 255 0 - 255 0 - 15 16 - 255 0 - 255 7 8 0 - 31 32 - 255 0 - 51 52 - 102 103 - 153 154 - 204 205 - 255 0 - 255 0 - 15 16 - 31 32 - 47 48 - 63 8 Channel - DMX Values & Functions Function RED 0% - 100% GREEN 0% - 100% BLUE 0% - 100% AMBER 0% - 100% MASTER DIMMER 0% - 100% STROBING/PROGRAM SPEED/ SOUND SENSITIVITY NO FUNCTION STROBING SLOW - FAST SPEED CONTROL SLOW - FAST SOUND SENSITIVITY NO FUNCTION LEAST SENSITIVE - MOST SENSITIV
PAGE 12
WiFLY Par QA5 Channel 8 Value 32 - 47 48 - 63 64 - 79 80 - 95 96 - 111 112 - 127 128 - 143 144 - 159 160 - 175 176 - 191 192 - 207 208 - 223 224 - 239 240 - 255 8 Channel - DMX Values & Functions Function SOUND ACTIVE MODE CONT.
PAGE 13
WiFly Par QA5 Photometric Chart WiFly Par QA5 Battery Replacement 1. Uscrew the four thumbscrews that hold the battery door in place. 2. Remove the battery door to access the battery. WiFly Par QA5 Dimmer Curve Chart Dim m er 3. Carefully remove the battery from the compartment. 100% 50% 4. Carefully pull out the battery connector cables.
PAGE 14
WiFly Par QA5 Fuse Replacement Disconnect the unit from its power source. Remove the power cord from the unit. Once the cord has been removed, you will find that the fuse holder is located inside the power socket. Insert a flat-head screw driver into the power socket and gently pry out the fuse holder. Remove the bad fuse and replace with a new one. The fuse holder also has a holder for a spare fuse. WiFly Par QA5 WiFly Par QA5 B.
PAGE 15
WiFly Par QA5 Notes ADJ Products, LLC - www.adj.com - WiFly Par QA5 User Manual Page 29 WiFly Par QA5 Notes ADJ Products, LLC - www.adj.
PAGE 16
WiFLY Par QA5 Model: WiFLY Par QA5 Specifications Voltage: 100V ~ 240V/50~60Hz Battery Life: 6 Hours Full On (Full Charge) Battery Lifetime*: Average Lifetime is 500 Charges LEDs: 5 x 5W Quad LEDs (RGBA 4-in-1) Beam Angle: 25 Degrees Working Position: Any safe working position Power Draw: 58W Power Cord Daisy Chain:10 Fixtures Max. Fuse: 2 Amp Weight: 10lbs./ 4.2Kgs. Dimensions: 10.5” (L) x 9.5” (W) x 6.