Instruction manual

©American DJ Supply® - www.americandj.com - FREQ 16 Strobe Instruction Manual Page 12©American DJ Supply® - www.americandj.com - FREQ 16 Strobe Instruction Manual Page 11
DOWN buttons to select “ON” to keep the LED display on at all
times, or “OFF” to allow the LED display to turn o after 2 min-
utes. Press any button to turn the LED display on again.
3. Press ENTER to conrm your selection.
DISP - This will “ip” the LED display
1. Press the MENU button until “DISP” is displayed, press
ENTER.
2. When “DISP” is displayed the LED display will remain normal,
when “DSIP” is displayed, the LED display will be “ipped”.
Use the ENTER button to nd your desired display set up, then
press MENU to conrm and exit.
TEST - This function will run a self test program.
1. Press the MENU button until “TEST” is displayed, press
ENTER.
2. The xture will now run a self test. Press the MENU button to
exit.
TEMP - With this function you can check the current tem-
perature of the xture.
1. Tap the MENU button until “TEMP” is displayed, press ENTER.
2. The current temperature of the xture will now be displayed.
Press MENU to exit.
FHRS - With this function you can display the running time
of the unit.
1. Press the MENU button until “FHRS” is displayed, press
ENTER.
2. The running time of the xture will now be displayed. Press
FREQ 16 Strobe System Menu FREQ 16 Strobe System Menu
MENU to exit.
VER - This will display the software version
1. Press the MENU button until “VER” is displayed. Press the
ENTER button and the software vesion will be displayed.
2. Press the MENU button to leave this function.