Instruction manual
©American DJ® - www.americandj.com - Hypnotic RGB Instruction Manual Page 15 ©American DJ® - www.americandj.com - Hypnotic RGB Instruction Manual Page 16
CAUTION IMPORTANT! When installing this projector, make sure
that it is mounted in a manner that prevents the audience from
looking directly into the beam, and the beam from striking the
audience.
Operating Modes: The Hypnotic RGB can operate in three dif-
ferent modes.
Sound Active Mode (Stand Alone or Master-Slave): This mode
allows either single unit or several units linked together, to run to the
beat of the music.
1. Press the MENU button until “SOUN” is displayed, and press
ENTER.
2. Press the UP or DOWN buttons so that “ON” is displayed, and
press ENTER to conrm and then hold MENU for at least 2-3 sec-
onds.
3. To adjust the sound sensitivity press the MENU button until
“SENS” is displayed and press ENTER. Use the UP or DOWN but-
tons to adjust sensitivity.
4. The optional UC3 Controller (not included) may be used to con-
trol different functions including blackout. See page 18 for UC3
controls and functions.
Show Mode (Stand Alone or Master-Slave): This mode allows a
single unit or several units linked together, to run your desired prepro-
grammed show.
1. Press the MENU button until “SHND” is displayed, and press
ENTER.
2. Press the UP or DOWN buttons until you nd your desired show,
press ENTER.
3. “r XXX” will now be displayed, use the UP and DOWN buttons to
adjust the rotation and speed of the program. Follow the values
listed under DMX Mode Channel 2 on page 18 to make your
adjustments. Press ENTER to conrm and then hold MENU for at
least 2-3 seconds.
4. The optional UC3 Controller (not included) may be used to con-
trol different functions including blackout. See page 18 for UC3
controls and functions.
Hypnotic RGB Operation
FHRS - With this function you can display the running time
of the xture.
1. Tap the MENU button until “FHRS” is displayed, press
ENTER.
2. The display shows the running time of the unit. Press MENU
to exit.
VER - With this function you can display the version soft-
ware of the unit.
1. Tap the MENU button until “VER” is displayed, press ENTER.
2. The display will now display the version of software. Press
MENU to exit.
Hypnotic RGB System Menu