Operating instructions

MENU PROGRAMMING
MENU PROGRAMMING
All AD2150 programming functions are accessed through on-
screen menus. All menus are displayed via the video output
for Monitor 1, on the rear panel of the AD2150. Until the
menu system is started, this output displays the camera video
that has been called to this monitor. Access to menu
programming is possible only from an AD1678CM,
AD2078A, or ADTT keyboard.
Note: As a security feature these keyboards have a keyswitch
which disables all setup functions when set to OFF.
To access Menu Programming:
Using an AD2078A keyboard:
1. Call Monitor number 1.
2. Place the keyswitch in the DISP position.
Using an AD1678C/CM keyboard:
1. Call Monitor number 1.
2. Place the keyswitch in the PROG position.
3. Enter 129 on the keypad.
4. Press the PROG button on the keyboard.
Using an ADTT keyboard:
1. Call Monitor number 1.
2. Press the DISPLAY button.
When the Main Selection Menu appears, the functions
associated with the dual function buttons are enabled and
provide navigation through the selections.
MAIN SELECTION MENU
The Main Selection menu is then displayed via the Monitor 1
output, indicating the setup functions available. One line of
the menu blinks, indicating the position of the cursor.
To select a Main Selection menu function:
1. Move the cursor to the desired line.
or
Enter the number (1 - 5) for the desired line.
2. Press the ACK button to access that selection.
Each selection of the Main Selection menu brings up another
menu, as illustrated at the bottom of this page. Refer to the
following pages for each menu procedures.
SYSTEM pages 4-3 to 4-12
MONITOR page 4-13
CAMERA page 4-14
PORTS pages 4-15 to 4-16
ACCESS pages 4-17 to 4-21
In each of these menus (shown below), move the cursor to the
RETURN MAIN line and press the ACK key to return to the
MAIN SELECTION menu.
The System and Access menus each provide additional menus
for selection.
To select an entry from any of these menus:
1. Move the cursor to the desired line.
or
Enter the number for the desired line.
2. Press the ACK button to access that selection.
When menu programming is completed, the user can exit from
the menu system from any menu displayed.
To Exit Menu Programming from an AD2078A keyboard:
1. Place the keyswitch in the OFF or PROG position.
To Exit Menu Programming from an AD1678C/CM keyboard:
1. Enter 130 on the keypad.
2. Press the PROG button on the keyboard.
To Exit Menu Programming from an ADTT keyboard:
1. Press the DISPLAY button. The dual function buttons
will return to their normal operation.
4-2
SYSTEM MONITOR CAMERA PORTS ACCESS
1 SET TIME AND DATE ARM TYPE ACK CONTROL PORT # 1 KEYBOARD/MONITOR
2 SET SYSTEM TOURS TOUR TITLE BAUD 2 KEYBOARD/CAMERA VIEW
3 SET SYSTEM SALVOS TIME/DATE RETURN MAIN DATA BITS 3 KEYBOARD/CAMERA CTRL
4 SET EVENT TIMERS TITLE DISPLAY PARITY 4 MONITOR/CAMERA ACCESS
5 SET ALARM CONTACTS CAM TITLE LCK STOP BITS 5 ARM CONTACTS
6 MONITOR STATUS MON TITLE LCK PORT USE RETURN MAIN
RETURN MAIN BRIGHTNESS RETURN MAIN
DISPLAY STATUS
RETURN MAIN
MAIN SELECTION
- - - - - - - - - - - - - -
1 SYSTEM
2 MONITOR
3 CAMERA
4 PORTS
5 ACCESS