Specifications

Matrix Installation and Operation

8. Move to the Communication option.

9. Use the right joystick command to select either OFF, UTC, SNET or SNET-V (for

SDU7 and above). Select UTC when AD Up-the-Cable (UTC) protocol is to be used

to communicate with the camera input or select SNET where Sensornet telemetry

control is to be used. Select OFF if the input does not use either of these

communication protocols.

10.If the Communication option is set to SNET, it is necessary to set an address for the

video input in the Physical Address field. The address that is entered must match

the input's local address (e.g., the address set inside the dome camera). It does not

need to match the video input number.

If the Communication option is set to UTC, the Physical address field will be disabled

and the address is automatically set to 891. Note that if a connected dome camera

is using UTC communication, the dome camera address must be set locally to 891.

11. The Channel option is only enabled when the Communication option is set to SNET.

This field should be set to A for MPLT 16 or A and B for MPLT 32. Verify that the

dome data connection is made to the correct port on the rear of the MPLT.

12.Once amendments are complete, select the Return to Menu option.

NOTES

• Video loss can only be reported on the selected camera.

• The feature will disable automatically if the video signal is changed.

System Menu

The System menu is used to change pin numbers, set up partitioning and to configure

monitor displays. It is also used to enable and disable the Program Preset feature.

Enabling and Disabling the Program Preset Feature

The Program Preset feature allows the installer the restrict users from altering preset

positions once installation has been completed.

To enable or disable the Program Preset feature, follow the steps below:

1. In the System menu, use the up/down joystick to move to Program Preset.

2. Use the right joystick command to enable (select Yes) or disable (select No) the

Program Preset feature.

3 System Menu

3.1 Change Pins

3.2 Partitioning

3.3 Monitor Display

3.4 Program Preset :YES

Return to Menu