Quick Setup Guide VideoEdge IP Outdoor Mini-dome Part Number 8200-2646-07 B0
Quick Setup Guide WARNING At close range, infrared light can seriously damage a person's vision. Install this illuminator with a minimum safety zone of 1.22m ( 4 ft. ) between the illuminator and the closest possible human contact. Note: 1.22m ( 4 ft. ) is the actual measurement of the strength of the IR Illuminators that are being used. Note: CAMERA STARTS UP IN BLACK & WHITE BECAUSE THE IR ILLUMINATOR IS DISCONNECTED. For safety reasons, the IR Illuminator is disconnected at the factory.
1. Name of parts and functions A. B. C. D. E. F. G. H. I. Inner plate mounting holes DC level Reset PC assembly IP module USB plug Side conduct entry Back conduct entry SD card slot 2. Adjusting the camera zoom and focus 1. 2. 3. 4. 5. 6. 4 Loosen the zoom ring thumbscrew. Turn the zoom ring to set the desired zoom. Tighten the zoom ring thumbscrew. Loosen the focus ring thumbscrew. Turn the focus ring to set the desired focus. Tighten the focus ring thumbscrew with the tool to adjust the focus.
Quick Setup Guide 3. Camera adjustment 1. Horizontal angle adjustment: turn the platform to adjust the horizontal angle B (90 degrees) and C (180 degrees). 2. Vertical angle adjustment: turn the platform to adjust the vertical angle A (90 degrees). 4.
5. Install, configure and set the IP Dome Camera The CAMERA default setting is DHCP OFF. Users can build the CAMERA working environment with a static IP address. The default static IP is 192.168.1.168. You can set an IP address for the CAMERA if the LAN unit isn’t connected to a DHCP server. Or turn on to use the DHCP protocol if the DHCP server is working in the LAN, the CAMERA will obtain an IP address automatically from the DHCP server.
Quick Setup Guide Step 2: Use the buttons below the images to enter any other operational settings pages. Step 3: When you change any setting, please remember to click the "Submit” button in each page. NOTE: Enable DHCP Function: This function can only work if the LAN, which the unit is connected to, has a DHCP server. If the DHCP server is working, the IP Dome Camera will obtain an IP address automatically from the DHCP server. NOTE: The default "User Name" and "Password" are admin and 9999 respectively.
