User guide

SENSORRAIL IIIE 8200-0593-03, REV. A
SERVICE GUIDE
29 of 34
Self-Tapping Screw Installation
Two self-tapping screws, one at each at each end
of the rail, prevent the PVC holder from coming out
of the rail.
Using a drill with a Phillips bit, thread each screw
into the rail as shown below. Ensure the screw
does not touch the copper or connector at the start
and end of the rail.
End Cover Replacement
If RF video dropouts occur, use the black plastic
end cover ADRL3ECB. Affix the plastic cover using
the same screws that held the metal version.
CAUTION: The black cover is only used
with the new rail extension containing
the top hat. DO NOT
use this cover
without the rail extension. See “Light
Reduction Kit” on page
25.