Installation Guide
Table Of Contents
- Overview
- Illustra Essentials Gen 4 Dome cameras
- Illustra Essentials Gen 4 Bullet cameras
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- Appendix E: Technical Specifications
- End User License Agreement (EULA)
Illustra Essentials Gen 4 Series Installation and Configuration Guide
8200-1929-03 A0 18
- End -
Adjusting the camera position
The camera has three axes to adjust the field of view for different Applications (Figure 19). While
screening live view on your monitor, adjust the axes as per the information below.
Figure 19 Adjusting the camera position
• Tilt Adjustment (A - Figure 19) Tilt this joint to adjust the camera vertically. The Tilt range
is 0° – 90°.
• Pan Adjustment (B - Figure 19) Rotate this joint to adjust the camera horizontally. DO
NOT rotate over the default limit of ± 360°.
• Locking Ring (C - Figure 19) Rotating the C ring counter-clockwise, the Pan & Tilt joints
loosen and you can adjust for different angles. Rotating the C ring clockwise fastens the
pan & tilt joints altogether.
- End -
Adjusting the protection shield hood
The protection shield hood protects the camera from both sunlight and rain.
Step Action
1 Use the L-Key (1) (Figure 20) to loosen the two screws located on the protection shield hood.
2 Slide the protection shield (2) (Figure 20) forward or backward until the correct position is
found.