Installation Guide
Table Of Contents
- Overview
- Illustra Essentials Gen 4 Dome cameras
- Illustra Essentials Gen 4 Bullet cameras
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- Appendix E: Technical Specifications
- End User License Agreement (EULA)
38 8200-1929-03 A0
Focus / Zoom
You can configure the focus and zoom using the Web User Interface. You can use the plus and
minus arrows to fine tune the image. The Zoom slider bar is used to manually zoom in and out to
manually configure to picture. The table below describes the features supported by each camera.
Table 29 Lens features supported for the Outdoor Dome
Varifocal Dome Varifocal Bullet
Motorized Focus X X
Motorized Zoom X X
Lens Calibration X X
Auto One Touch X X
Procedure 24 Adjust Camera Focus / Zoom
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select the Picture Basic tab from the Basic Configuration menu.
3 Select to start the video stream if it is not already active.
4 Use the arrows to manually configure the focus and the slider bar to adjust zoom settings
until the image is clear. The video pane updates to display the new settings.
- End -
Procedure 25 Adjust Camera Focus using OneTouch Autofocus
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select the Picture Basic tab from the Basic Configuration menu.
3 Select to start the video stream if it is not already active.
4 In the Focus/Zoom section, click the One Touch button.The camera refocuses to the
zoom level selected for the image.
The video pane updates to display the new settings.
Note:The user can create a ROI focus point for the camera to use during the one touch procedure -
use the pencil icon and highlight the desired ROI.
- End -
Exposure
Configure the exposure settings for the camera.