Installation Guide

51 8200-1929-03 A0
Note:When wall mounting the camera you should select Flip to correct the lens
orientation.
- End -
Focus/Zoom
The Focus is manually configured on initial setup. The One Touch button can be used to
automatically focus the area of view. The plus and minus arrows are used to manually fine tune the
image. The Zoom slider bar is used to manually zoom in and out to manually configure to picture. The
table below describes the features supported by each camera.
Table 32 Lens features supported for the Outdoor Dome and Bullet cameras
Varifocal Dome Varifocal Bullet
Motorized Focus X X
Motorized Zoom X X
Lens Calibration X X
Auto One Touch X X
Procedure 42 Adjust Camera Focus / Zoom
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select the Picture Basic tab from the Basic Configuration menu.
3 Select to start the video stream if it is not already active.
4 Use the arrows to manually configure the focus and the slider bar to adjust zoom settings
until the image in clear. The video pane updates to display the new settings.
- End -
Procedure 43 Adjust Camera Focus using OneTouch Autofocus
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select the Picture Basic tab from the Basic Configuration menu.
3 Select to start the video stream if it is not already active.
4 In the Focus/Zoom section, click the One Touch button.The camera refocuses to the
zoom level selected for the image.
The video pane updates to display the new settings.
Note:The user can create a ROI focus point for the camera to use during the one touch procedure -
use the pencil icon and highlight the desired ROI.
- End -