Installation Guide

68 8200-1929-03 A0
Note:
1 If the motion detection video stream is changed after the region of interest has been drawn it
is necessary to re-draw a new region.
2 If the stream settings are modified the motion detection is disabled and it is necessary to
enable motion detection again if required.
Procedure 71 Create a Motion Detection Alert
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Analytics from the Events and Actions menu.
3 Select the Motion Detection tab.
4 Select the Enable motion detection check box to enable Motion Detection on the camera.
OR
Clear the Enable motion detection check box to disable Motion Detection on the camera.
5 Select the zone for detection in the Motion zone drop-down list.
6 Select the Enable motion zone check box to enable the zone for motion detection.
7 Select Edit in the Region configuration field.
Note:The user can configure three seperate rules each with a different region, sensitivity and fault
actions.
8 Use the drawing tools on the Motion Detection Configuration Pane to draw the region of
interest on the pane. Multiple selections can be made.
9 Select the sensitivity from the Sensitivity drop-down menu:
• High
• Medium
• Low
10 Select the fault action from the Action drop-down menu.
This fault action activates when motion is detected in the selected region of interest.
11 Select Apply to save the changes.
- End -
Enable or Disable a Motion Detection Alert
Motion detection can be turned on and turned off when required.
Procedure 72 Enable or Disable a Motion Detection Alert
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Analytics from the Events and Actions menu.
3 Select the Motion Detection tab.
The Motion Detection Configuration pane displays.