Installation Guide

Illustra Essentials Gen 4 Series Installation and Configuration Guide
8200-1929-03 A0 78
• ICMP (Internet Control Message Protocol) Blocking
• RP (Reverse Path) Filtering
Procedure 87 Enable/Disable Basic Filtering
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Firewall from the Security menu.
The Basic Filtering tab displays.
3 Select the ICMP Blocking check box to enable ICMP blocking.
OR
Clear the ICMP Blocking check box to disable ICMP blocking. The default setting is
‘Disabled’.
4 Select the RP Filtering check box to enable the RP filtering.
OR
Deselect the RP Filtering check box to disable.
The default setting is ‘Disabled’.
- End -
Address Filtering
Configure the IP or MAC addresses which are denied access to the camera.
Procedure 88 Enable/Disable and configure Address Filtering
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Firewall from the Security menu.
3 Select the Address Filtering tab.
4 Select Off to disable address filtering completely.
OR
Select Allow to allow address filtering for specified addresses
OR
Select Deny to deny address filtering for specific addresses.
The default setting is ‘Off’.
5 If address filtering has been set to Allow or Deny:
a Enter an IP or MAC Address to allow / deny in the IP or MAC Address text box in the
following format xxx.xxx.xxx.xxx.
Note:CIDR (Classless Inter-Domain Routing) is supported when using address
filtering. If using a CIDR address use the following format xxx.xxx.xxx.xxx/xx.
b Select Add.
6 Select Apply to save the settings.