Installation Guide
Table Of Contents
- Overview
- Illustra Essentials Gen 4 Dome cameras
- Illustra Essentials Gen 4 Bullet cameras
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- Appendix E: Technical Specifications
- End User License Agreement (EULA)
79 8200-1929-03 A0
- End -
Editing an Address Filter
Edit an existing address filter.
Procedure 89 Edit an Address Filter
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Firewall from the Security menu.
3 Select the Address Filtering tab.
4 Edit the IP or MAC Address in the IP or MAC Address text box.
5 Select Add to save the changes.
- End -
Deleting an Address Filter
Delete an existing address filter.
Procedure 90 Delete an Address Filter
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Firewall from the Security menu.
3 Select the Address Filtering tab.
4 Select to delete the corresponding address filter.
- End -
Remote Access
SSH Enable
Enables Secure Shell access into the camera, if remote access is permitted by the camera network.
This will also enable Tyco Security Products Level 3 Technical Support to diagnose any problems on
the camera.
Note:It is recommended to keep SSH Enable disabled. This function should only be enabled this
when it is requested by Tyco Security Products Level 3 Technical Support.
Procedure 91 Configure SSH
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Remote Access from the Security menu.
The Remote Access tab displays.