Installation Guide

Illustra Essentials Gen 4 Series Installation and Configuration Guide
8200-1929-03 A0 80
3 Select the SSH Enable check box to enable SSH.
OR
Deselect SSH Enable check box to disable SSH.
The default setting is ‘Disabled’.
- End -
ONVIF
The Web User Interface allows ONVIF functionality to be managed at a high level. ONVIF Discovery
Mode and User Authentication can be enabled or disabled.
• ONVIF Discovery Mode allows enabling or disabling discovery of the camera via ONVIF.
• ONVIF User Authentication allows the camera to accept ONVIF commands from all users
or only authenticated users. Enabling User Authentication ensures the camera will only
execute commands from authenticated users.
The separation of Discovery Mode and User Authentication allows the camera to be set up in a
configuration that suits requirements for the network and users. The preferred discovery method for
the camera is Illustra Connect, and this utilizes ONVIF discovery. It is therefore recommended that
ONVIF Discovery Mode is always enabled.
ONVIF Discovery Mode
Enable or disable ONVIF discovery on the camera.
Procedure 92 Enable/Disable ONVIF Discovery Mode
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Remote Access from the Security menu.
The Remote Access tab displays.
3 Select the ONVIF Discovery Mode check box to enable ONVIF Discovery Mode.
OR
Deselect ONVIF Discovery Mode check box to disable ONVIF Discovery Mode.
The default setting is ‘Enabled’.
- End -
ONVIF User Authentication
To utilize ONVIF User Authentication, there must be at least one admin level user in the ONVIF
service.
Note:When in Enhanced Security mode, editing ONVIF User Authentication requires the admin
account password.
Procedure 93 Enable/Disable ONVIF User Authentication
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Remote Access from the Security menu.