Installation Guide

Illustra Essentials Gen 4 Series Installation and Configuration Guide
8200-1929-03 A0 87
- auth: Authentication / no encryption. A user password is required. It is symmetrically
encrypted using either MD5 or SHA.
- priv: Authentication / encryption. A user password is required as is symmetrically
encrypted using either MD5 or SHA. A data encryption password is required as is sym-
metrically encrypted using either DES or AES.
d Select the Authentication Type using the radio buttons.
e Enter the Authentication Password
f Select the EncryptionType using the radio buttons.
g Enter the Encryption Password
h Select Apply.
- End -
Heartbeat
Procedure 104 Enable/Disable Heartbeat
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select SNMP from the Network menu.
3 Select the Heartbeat tab.
4 Select the Enable Heartbeat check box to enable Heartbeat.
OR
Deselect the Enable Heartbeat check box to disable Heartbeat.
The default setting is ‘Disabled’.
- End -
Procedure 105 Enable select Heartbeat intervals
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select SNMP from the Network menu.
3 Select the Heartbeat tab.
4 Select the Enable Heartbeat check box to enable Heartbeat.
5 Use the slider bar to select the Heartbeat Interval (secs).
6 The default setting is ‘60' seconds. The seconds range from 5 to 500.
- End -
Dynamic DNS
Dynamic DNS is supported for updating, in real time a changing IP address on the Internet to provide
a persistent domain name for a resource that may change location on the network. RFC 2136
Dynamic Updates in the Domain Name System. In this situation the camera talks only to the DHCP