Installation Guide
Table Of Contents
- Overview
- Illustra Essentials Gen 4 Dome cameras
- Illustra Essentials Gen 4 Bullet cameras
- Network Topology
- Network Connection
- Configuration
- Appendix A: User Account Access
- Appendix B: Using Media Player to View RTSP Streaming
- Appendix C: Stream Tables
- Appendix D: Camera Defaults
- Appendix E: Technical Specifications
- End User License Agreement (EULA)
Illustra Essentials Gen 4 Series Installation and Configuration Guide
8200-1929-03 A0 90
Procedure 107 Resetting the Camera
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Maintenance from the System menu.
3 Select the Preserve IP address check box to retain the current network settings during the
camera reset.
OR
Deselect the Preserve IP address check box to restore the default networking settings.
The default setting is ‘Enabled’.
4 Select Reset.
You will be prompted to confirm the camera reset.
• Select OK to confirm. The Web User Interface will display a “Camera
Resetting” page with a progress bar showing the reboot progress.
• When the camera is restarted it will take 2 - 3 minutes until it is online
and ready to be accessed and controlled.
OR
Select Cancel.
5 The Log in page displays.
- End -
Reboot
To perform a physical reset of the camera, refer to the chapter regarding your camera model in this
guide.
Procedure 108 Reboot the Camera
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Maintenance from the System menu.
3 Select Reboot.
You will be prompted to confirm the camera reboot.
4 Select OK to confirm.
The Web User Interface will display a “Camera Rebooting” page with a progress bar
showing the reboot progress.
When the camera is restarted it will take 2 - 3 minutes until it is online and ready to be
accessed and controlled.
OR
Select Cancel.
5 The Log in page displays.
- End -