Installation Guide

91 8200-1929-03 A0
Camera Firmware Upgrade
The camera can be upgraded using firmware provided by Illustra. Alternatively, the camera can also
be upgraded using Illustra Connect. Refer to the Illustra Connect User Guide for further information.
Note:All existing camera settings are maintained when the firmware is upgraded.
Caution
You should only use firmware that has been provided by Illustra. Using any other firmware may
cause a malfunction and damage the camera.
Procedure 109 Upgrade Camera Firmware
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Maintenance from the System menu.
3 Select Choose File.
The Choose file to Upload dialog displays.
4 Navigate to the location where the firmware file has been saved.
5 Select the firmware file then select the Open button.
6 Select Upgrade.
The file transfer will begin. Do not disconnect power to the camera during the upgrade
process. The camera restarts automatically after the updates have been completed, this can
take from 1 to 10 minutes. The Log in page displays.
- End -
Backup/Restore
Backup camera data and restore from a previously saved data file. The data file can be saved to a
specified location and used to restore the camera configuration.
Note:A saved backup data file created on a camera is camera specific and cannot be used to restore
the settings on a different camera.
Procedure 110 Backup Camera Data
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Maintenance from the System menu.
3 Select the Backup/Restore tab.
4 Select Backup. You are prompted to save the backup file.
5 Select Save.
- End -