Installation Guide

Illustra Essentials Gen 4 Series Installation and Configuration Guide
8200-1929-03 A0 92
Procedure 111 Restore Camera from Backup
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Maintenance from the System menu.
3 Select the Backup/Restore tab.
4 Select Choose File.
The Choose file to Upload dialog displays.
5 Navigate to the location where the firmware file has been saved.
6 Select the firmware file then select the Open button.
7 Select Upload.
The file transfer begins. Do not disconnect power to the camera during the upgrade process.
The camera restarts automatically after the updates have been completed, this can take
from 1 to 10 minutes. The Log in page displays.
- End -
Date / Time
Set the date and time on the camera.
Note:
Date and Time can also be configured in the Quick Start menu.
Procedure 112 Configuring the Date and Time
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select the Date/Time from the Basic Configuration menu.
3 Select the Time 24-hour check box to enable the 24-hour clock.
Or
Deselect the Time 24-hour check box to enable the 12-hour clock.
The default setting is ‘24-hour’.
4 Select the Date Display Format from the drop-down menu:
• DD/MM/YYYY
• MM/DD/YYYY
• YYYY/MM/DD
The default setting is ‘DD/MM/YYYY’.
5 Select the Time Zone from the drop-down menu.
The default setting is (GMT) GMT+0.
6 Select the Set Time setting by selecting the radio buttons: