Product data

VideoEdge NVR 4.1 Release Notes
40
8200-2735-07 D0
5. Video standard has been wrongly represented in this case as video mode,
which is 1.3 megapixel mode, with 4:3 and 16:9 aspect ratio settings.
6. Image white-balance supports 3 settings, namely:
 “1” – Auto White balance control mode
 “2” – Auto tracking white balance mode
 “3” – Auto tracking white balance under a sodium lamp mode
7. When using MJPEG if a high quality setting is used while using the highest
resolution of 1280x960, it results in streaming at a very high bitrate. This
results in problem with Quick time playing out the stream, as there is
limitation of playback of streams with high bitrate by Quicktime. However
VLC seems to play it out quite fine. Solution is to use lower quality settings,
maybe within 75 for this resolution usage.
NP304, NF302
1. Picture quality is 1.3 mega pixels; there are two aspect ratios 4:3 & 16:9.
MPEG-4 is not available when 16:9 is selected.
2. When MPEG-4 transmission is set to On, the maximum frame rate for
MJPEG is 5fp.
3. The maximum MPEG4 resolution is 1280x960. The maximum MJPEG
resolution is 640x480.
4. By default, the MPEG-4 capability is turned off programmatically. This will
effectively disabled the audio capability, since the Panasonic handler
utilizes MPEG-4 stream for audio streaming.
5. MJPEG frame rate can be reduced if MPEG4 is manually enabled directly
through the camera‟s web interface.
6. The mode settings of H.264 and MPEG-4 operation needs to be explicitly
set at the camera.
7. Video standard has been wrongly represented in this case as video mode,
which is 1.3 megapixel mode, with 4:3 and 16:9 aspect ratio settings.
8. Image white-balance supports 3 settings, namely:
 “1” – Auto White balance control mode
 “2” – Auto tracking white balance mode
 “3” – Auto tracking white balance under a sodium lamp mode
9. For NP304, it is not recommended to use audio in this model due to the
camera limitation on the number of RTSP session. Using audio might
resulted in losing live video.
10. For NF302, at very low frame-rate settings for MPEG-4, e.g. 1fps – 3 fps it
has been observed the effective frame-rate is much lower of the order
between 0.5 fps – 1.5 fps. It is recommended to use higher frame-rate
settings in these models.
NS202, NS202A
1. By default, the MPEG-4 capability is turned off programmatically. This will
effectively disabled the audio capability, since the Panasonic handler
utilizes MPEG-4 stream for audio streaming.
2. MJPEG frame rate can be reduced if MPEG4 is manually enabled directly
through the camera‟s web interface.
3. Number of presets supported is 64.
4. Image white-balance supports 3 settings, namely:
 “1” – Auto White balance control mode
 “2” – Auto tracking white balance mode
 “3” – Auto tracking white balance under a sodium lamp mode
NP244, NF284
1. When MPEG-4 transmission is set to On, the maximum frame rate for