Product data

VideoEdge NVR 4.1 Release Notes

8200-2735-07 D0

MJPEG is 5fp.

2. By default, the MPEG-4 capability is turned off programmatically. This will

effectively disabled the audio capability, since the Panasonic handler

utilizes MPEG-4 stream for audio streaming.

3. MJPEG frame rate can be reduced if MPEG4 is manually enabled directly

through the camera‟s web interface.

4. Image white-balance supports 3 settings, namely:

 “1” – Auto White balance control mode

 “2” – Auto tracking white balance mode

 “3” – Auto tracking white balance under a sodium lamp mode

5. It is not recommended to use audio in this model due to the camera

limitation on the number of RTSP session. Using audio might resulted in

losing live video.

6. For NP244, at very low frame-rate settings for MPEG-4, e.g. 1fps – 3 fps it

has been observed the effective frame-rate is much lower of the order

between 0.5 fps – 1.5 fps. It is recommended to use higher frame-rate

settings in these models.

SC385, SW395

1. Although G.711 Audio codec is available on the camera, it is not supported

in this release due to the lack of camera API support in this version of the

camera firmware.

2. The mode settings of H.264 and MPEG-4 operation needs to be explicitly

set at the camera.

3. Video standard has been wrongly represented in this case as video mode,

which is 1.3 megapixel mode, with 4:3 and 16:9 aspect ratio settings.

4. Number of presets supported is 64.

5. Audio stream is not working with WV-SC385, as the device is still rejecting

the request to establish an Audio only RTSP/RTP session.

6. Image white-balance supports 3 settings, namely:

 “1” – Auto White balance control mode

 “2” – Auto tracking white balance mode

 “3” – Auto tracking white balance under a sodium lamp mode

Generic Fixed

1. Does not support any other settings other than video, audio and event

stream related functions.

2. The mode settings of H.264 and MPEG-4 operation need to be explicitly

set at the camera.

3. On providing an incorrect password or configuring incorrect password

group to Panasonic camera there is some behavioral difference from other

camera families where certain properties are shown as “unknown” and

certain GET only device properties are still displayed (like mac-address,

firmware version information, serial number etc…).

NOTE: Please refer to Panasonic Camera Release Notes published by Panasonic for additional

information.