Installation Guide
Table Of Contents
- Overview
- Illustra PG4 Series 2MP, 4MP and 8MP Indoor / Outdoor Dome Cameras
- Network Topology
- Network Connection
- Configuration
- Appendix A: Using Media Player to View RTSP Streaming
- Appendix B: Stream Tables
- Appendix C:Technical Specifications
- End User License Agreement (EULA)
103 8200-2007-08 A0
Remote Access
SSH Enable
Enables Secure Shell access into the camera, if remote access is permitted by the camera network.
This will also enable Tyco Security Products Level 3 Technical Support to diagnose any problems on
the camera.
Note:It is recommended to keep SSH Enable disabled. This function should only be enabled this
when it is requested by Tyco Security Products Level 3 Technical Support.
Procedure 125 Configure SSH
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Remote Access from the Security menu.
The Remote Access tab displays.
3 Select the SSH Enable check box to enable SSH.
OR
Deselect SSH Enable check box to disable SSH.
The default setting is ‘Disabled’.
- End -
ONVIF
The Web User Interface allows ONVIF functionality to be managed at a high level. ONVIF Discovery
Mode and User Authentication can be enabled or disabled.
• ONVIF Discovery Mode allows enabling or disabling discovery of the camera via ONVIF.
• ONVIF User Authentication allows the camera to accept ONVIF commands from all users
or only authenticated users. Enabling User Authentication ensures the camera will only
execute commands from authenticated users.
The separation of Discovery Mode and User Authentication allows the camera to be set up in a
configuration that suits requirements for the network and users. The preferred discovery method for
the camera is Illustra Connect, and this utilizes ONVIF discovery. It is therefore recommended that
ONVIF Discovery Mode is always enabled.
ONVIF Discovery Mode
Enable or disable ONVIF discovery on the camera.