Installation Guide
Table Of Contents
- Overview
- Illustra PG4 Series 2MP, 4MP and 8MP Indoor / Outdoor Dome Cameras
- Network Topology
- Network Connection
- Configuration
- Appendix A: Using Media Player to View RTSP Streaming
- Appendix B: Stream Tables
- Appendix C:Technical Specifications
- End User License Agreement (EULA)
Illustra Pro Gen 4 2MP, 4MP and 8MP Domes Installation and Configuration Guide
8200-2007-08 A0 120
Note:Network settings can be retained if required.
Procedure 151 Resetting the Camera
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Maintenance from the System menu.
3 Select the Preserve IP address check box to retain the current network settings during the
camera reset.
OR
Deselect the Preserve IP address check box to restore the default networking settings.
The default setting is ‘Enabled’.
4 Select Reset.
You will be prompted to confirm the camera reset.
• Select OK to confirm. The Web User Interface will display a “Camera
Resetting” page with a progress bar showing the reboot progress.
• When the camera is restarted it will take 2 - 3 minutes until it is online
and ready to be accessed and controlled.
OR
Select Cancel.
5 The Log in page displays.
- End -
Reboot
To perform a physical reset of the camera, refer to the chapter regarding your camera model in this
guide.
Procedure 152 Reboot the Camera
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Maintenance from the System menu.
3 Select Reboot.
You will be prompted to confirm the camera reboot.
4 Select OK to confirm.
The Web User Interface will display a “Camera Rebooting” page with a progress bar
showing the reboot progress.
When the camera is restarted it will take 2 - 3 minutes until it is online and ready to be
accessed and controlled.
OR
Select Cancel.
5 The Log in page displays.