Installation Guide
Table Of Contents
- Overview
- Illustra PG4 Series 2MP, 4MP and 8MP Indoor / Outdoor Dome Cameras
- Network Topology
- Network Connection
- Configuration
- Appendix A: Using Media Player to View RTSP Streaming
- Appendix B: Stream Tables
- Appendix C:Technical Specifications
- End User License Agreement (EULA)
123 8200-2007-08 A0
- End -
Procedure 157 Resetting the camera to normal operation
Note:There are two procedures for resetting the camera, please select one.
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Maintenance from the System menu.
3 Select the Maintenance tab. This page displays two types of factory reset:
a Factory Reset: Resets the camera and boots the camera in Illustra mode.
b Cloudvue Reset: Resets the camera and boots the camera in Cloudvue mode.
4 If you do not have the credentials to perform a reset, you can perform a factory reset on the
hardware itself by using the hardware reset button as detailed in the Product Overview of
each camera.
- End -
Date / Time
Set the date and time on the camera.
Note:Date and Time can also be configured in the Quick Start menu.
Procedure 158 Configuring the Date and Time
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select the Date Time from the System menu.
3 Select the Time 24-hour check box to enable the 24-hour clock.
Or
Deselect the Time 24-hour check box to enable the 12-hour clock.
The default setting is ‘24-hour’.
4 Select the Date Display Format from the drop-down menu:
• DD/MM/YYYY
• MM/DD/YYYY
• YYYY/MM/DD
The default setting is ‘YYYY/MM/DD’.
5 Select the Time Zone from the drop-down menu.
The default setting is ‘(GMT-05:00) Eastern Time (US & Canada)
6 Select the Set Time setting by selecting the radio buttons:
• Manually
• via NTP