Installation Guide

Illustra Pro Gen 4 2MP, 4MP and 8MP Domes Installation and Configuration Guide
8200-2007-08 A0 131
Inserting the Micro SD Card
When inserting a Micro SD Card it is essential that the camera is rebooted. The Micro SD Card
should be mounted and unmounted through the Web User Interface. If you receive a 'Device is Busy'
model you should wait and try again in a few minutes. If this does not work then it may be necessary
to disable Motion Detection, FTP or any other process which may be using the Micro SD Card.
Note:Refer to the Quick Reference Guide supplied with the product for details on how to remove the
housing assembly and gain access to the camera.
Procedure 172 Insert the Micro SD Card by powering down the Camera
Step Action
1 Turn off the camera by disconnecting the power supply.
2 Insert the Micro SD card into the camera.
3 Reconnect the power supply and power up the camera.
- End -
Procedure 173 Mount the Micro SD Card through the Web User Interface to
reboot the Camera
Step Action
1 Insert the Micro SD card into the camera.
2 Select Setup on the Web User Interface banner to display the setup menus.
3 Select SD Card Management menu from the Edge Recording menu.
4 Select Mount.
- End -
Removing the Micro SD Card
If at any stage you need to remove the Micro SD card from the camera one of the following two
procedures should be used:
• Remove the Micro SD Card by powering down the camera - Use this procedure if you
do not have access to the Web User Interface and are unable to unmount the Micro SD
card before removal.
• Unmount the Micro SD Card for Removal - Use this procedure when you are unable to
access the power supply to the camera.
Note:Refer to the Quick Reference Guide supplied with the product for details on how to remove the
housing assembly and gain access to the camera.