Installation Guide

132 8200-2007-08 A0
Procedure 174 Remove the Micro SD Card by powering down the Camera
Step Action
1 Turn off the camera by disconnecting the power supply.
2 Remove the Micro SD card from the camera.
Note:AVI clips are not available on the camera until the Micro SD card has been
inserted and the camera rebooted.
3 Reconnect the power supply and power up the camera.
- End -
Procedure 175 Unmount the Micro SD Card for Removal
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select SD Card Management menu from the Edge Recording menu.
3 Select Unmount.
You are prompted to confirm the unmounting.
4 Select OK to confirm.
OR
5 Select Cancel.
Remove the Micro SD card from the camera.
AVI clips are not available on the camera until the Micro SD card has been inserted and
mounted.
- End -
Encrypted SD card storage
Introduction of the Encrypted SD Card storage feature which offers encryption for the entire contents
of their SD card. When SD card Encryption is enabled the contents of the SD Card will only be
accessible through the Camera Web GUI, unless a Custom Password has been set which allows
password protected access to the SD card when mounted elsewhere. Currently this mounting is only
supported on Linux systems.
NOTE: The user can disable Encrypted SD Card storage to revert to being able to access the SD
card via Windows based systems, without a Password.
Disabling SD card encryption is not recommended.
Procedure 176 Encrypting the contents on the SD card
Step Action
1 Insert the SD card into camera.
2 Log in to the camera Web GUI and select Setup on the Web User Interface banner to
display the setup menus.
3 Select SD Card Management from the Edge Recording menu.