Installation Guide
Table Of Contents
- Overview
- Illustra PG4 Series 2MP, 4MP and 8MP Indoor / Outdoor Dome Cameras
- Network Topology
- Network Connection
- Configuration
- Appendix A: Using Media Player to View RTSP Streaming
- Appendix B: Stream Tables
- Appendix C:Technical Specifications
- End User License Agreement (EULA)
Illustra Pro Gen 4 2MP, 4MP and 8MP Domes Installation and Configuration Guide
8200-2007-08 A0 133
Note:The SD card will show as unmounted with encryption enabled.
Note:Encryption is always enabled by default after the camera has been reset. The
user may disable encryption mode but any change to the encryption status requires
the SD card to be formatted.
4 Format the SD card by selecting Format and select Mount to mount the encrypted SD card.
Note:The SD card will fail to mount until it has been formatted. The user now has
the option to encrypt SD card with a custom password.
The Custom Password is only required when the SD card is accessed independently from
the camera. It will not affect SD card functionality while it is being used by the camera.
5 Log in to the camera Web GUI and select SD Card Management from the Edge
Recording menu.
6 Select ‘Encrypt SD card with custom password’.
7 Enter the custom password into both password fields and select Save.
Note:Once the Custom Password has been set, it can be edited or cleared at any
time in the SD Card Management tab under the Edge Recording menu.
The Custom Password will remain set after a firmware upgrade. The Custom Password will
be cleared after a reset.
The SD Card Encryption can be disabled at any time by unticking ‘Encrypt entire contents of
SD card’. However any changes to the encryption status requires the SD card to be
formatted.
- End -
Procedure 177 Resetting a camera
Step Action
Note:The SD card encryption is always enabled by default after a camera reset
1 Log in to camera Web GUI and select Setup on the Web User Interface banner to display
the setup menus.
2 Select Maintenance from the System menu.
3 Select Reset and OK.
Note:Wait for the Reset process to complete.
4 Log in to the camera Web GUI and run through the initial setup.
5 Select SD Card Management from the Edge Recording menu.
• If SD card Encryption was enabled before reset and the same HostID
is used after reset, the SD card will show as mounted and Encryption
will be enabled.
• If SD card Encryption was enabled before reset and a different HostID
is used, the SD card will show as unmounted and Encryption will be
enabled. SD card will need to be formatted before it can be mounted by
the camera.