Installation Guide

Illustra Pro Gen 4 2MP, 4MP and 8MP Domes Installation and Configuration Guide
8200-2007-08 A0 16
Procedure 3 Installing the camera onto a wall or ceiling
Step Action
1 Use the T20 security key to remove the three screws on the dome cover (2) (Figure 3).
2 Use a screw driver to remove the safety lanyard screw that is connecting the dome cover to
the camera. Note: The dome cover is now completely disconnected from the camera.
3 Insert the cables through one of the waterproof rubbers:
a if you are using the three hole waterproof rubber then pierce three holes as per the three
circles on the rubber, insert the cable through the three rubber holes and then terminate
the cable.
OR
a if you are using the one hole waterproof rubber then pull the rubber pin to make the cable
hole, insert the terminated cable into the insert tool and then .pull the insert tool through
the hole.
4 Hold the guide pattern sticker up to the surface and drill four 6mm holes and if you are not
using the cable side entry hole on the bottom case then cut out a cable entry hole on the
surface as per the guide pattern.
Note:If you are not using the cable side entry hole then insert the cable cover.
5 Use a hammer to insert the four screw anchors (1) (Figure 13) into the holes
6 Hold the camera bottom case (2) (Figure 13) up to the surface and align the four 6mm holes
on the surface with the four holes in the bottom case (remove the rubber inserts in the
bottom case first).
7 Insert the four TP 32mm screws (3) (Figure 13) and securely attach the bottom case to the
surface.
8 Pull the camera power cables through the cable hole on the surface or the side entry hole on
the bottom case.
9 Hold the camera (4) (Figure 13) up to the bottom case and connect the cables to their
respective ports on the camera.
10 Insert the camera into the bottom case and use a T20 security key to securely attach the
camera to the bottom base with the three T10 screws.
11 Adjust the camera lens position as per step 9 in the Installing the camera in to a recess
ceiling procedure.
12 Screw the safety lanyard screw into the camera so that the dome cover is attached to the
camera.
13 Hold the dome cover (5) (Figure 13) up to the camera and align the three screws in the dome
cover with the three holes on the camera.
14 Use the T20 security key to securely attach the three screws to the camera.