Installation Guide
Table Of Contents
- Overview
- Illustra PG4 Series 2MP, 4MP and 8MP Indoor / Outdoor Dome Cameras
- Network Topology
- Network Connection
- Configuration
- Appendix A: Using Media Player to View RTSP Streaming
- Appendix B: Stream Tables
- Appendix C:Technical Specifications
- End User License Agreement (EULA)
32 8200-2007-08 A0
- End -
IPv4
Configure the IPv4 network settings for the camera.
Procedure 19 Configure the IPv4 Settings
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select the TCP/IP tab in the Basic Configuration menu.
3 Select the Enable DHCP check box to enable DHCP and disable manual settings.
OR
Clear Enable DHCP to disable DHCP and allow manual settings to be entered.
The default setting is ‘Enabled’.
4 If Enable DHCP has been disabled:
a Enter the IPv4 Address in the IPv4 Address text box in the form xxx.xxx.xxx.xxx.
The default setting is ‘192.168.1.168’
b Enter the Network Mask in the Network Mask text box xxx.xxx.xxx.xxx.
The default setting is ‘255.255.255.0’
c Enter the Gateway IP address in Gateway text box xxx.xxx.xxx.xxx.
d Enter the Primary DNS Server in the Primary DNS Server text box xxx.xxx.xxx.xxx.
5 Select Apply to save the settings.
- End -
IPv6
Enable or disable IPv6 on the camera.
Procedure 20 Enable/Disable IPv6
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select the TCP/IP tab in the Basic Configuration menu.
3 Select the IPv6 Enable check box to enable IPv6 on the camera.
OR
Clear the IPv6 Enable check box to disable IPv6 on the camera.
The default setting is ‘Enabled’.
If IPv6 is enabled the Link Local and DHCP address display beside ‘Current IPv6
Addresses’ if available.
- End -
Video Stream Settings
You can configure three video streams on the camera: Stream 1, Stream 2, and Stream 3.