Installation Guide

Illustra Pro Gen 4 2MP, 4MP and 8MP Domes Installation and Configuration Guide
8200-2007-08 A0 48
Integration with other Illustra API Clients
You can configure the 4 video streams through the Web User Interface, as detailed here, or through
the Illustra API interface. Changes made to the streams through either method are applied and the
video displays according to the configuration.
Opening the Web User Interface live video allows the stream to be shared with the Illustra API and
will minimize the impact on camera resources.
Configuring the Video Stream
Adjust the settings for each video stream.
Procedure 42 Configure the Video Stream settings
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select the Streams tab in the Video menu.
3 Select either Stream 1, 2, 3 or 4 from the Stream Number drop-down menu.
4 Select the required Codec from the drop-down list:
• H264
• H264 IntelliZip
• H265
• H265 IntelliZip
• MJPEG
The default setting is ‘H264’.
Note:When you select H264 or H264 IntelliZip you can set the Profile. If you do not select either of
these options then contiune at step 6 below.
5 Select the required Profile from the drop-down list:
• Main
• High
The default setting is ‘Main’.
6 Select the required Resolution from the drop-down menu.
The resolutions available depend on the Image Source selected.
Note:See Stream Tables combinations in Appendix B.
7 Use the slider bar to select the Frame Rate (fps).
Note:FPS varies depending on other features - See Stream Tables combinations in Appendix B.
8 Use the slider bar to select the GOP.
9 If MJPEG has been selected, MJPEG Quality is enabled. Use the slider bar to select the
MJPEG Quality.
The default setting is 50.
OR