Installation Guide

86 8200-2007-08 A0
Object Detection - Overlap (%) - The amount of a detected object that must be in the region
of interest before an alarm is triggered. Use a higher setting to detect objects that are mostly
inside the region, and use a lower value to find objects that just brush the edge of the region.
Linger
Overlap (%) - The amount of detected object that must be in the region of interest while
lingering for an alarm to be triggered. Use a higher setting to avoid detecting objects lingering
nearby.
Linger Time - The minimum amount of time an object lingers before the alarm is triggered.
Dwell
Overlap (%) - The amount of a detected object that must dwell in the region of interest for an
alarm to be triggered.
Dwell Time - This is the minimum amount of time that an object must dwell in the region of
interest before the alarm is triggered.
Perimeter
Select Area - Additional tools display when using perimeter to highlight zones of interest.
Use these tools to define the zones of interest for the protected area and the perimeter area.
Each selection is highlighted via a different color (perimeter area = green, protected area =
yellow).
Linger Time - The minimum amount of time an object lingers before the alarm is triggered.
- End -
Procedure 97 Enable/Disable an Analytics Rule in AI Object Classification
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Analytics from the Events and Actions menu.
3 Select the AI Object Classification tab.
4 From the Analytics Rules table, select the check box of the target Analytics Rule to enable
the analytics rule
OR
Deselect the check box of the target Analytics Rule to disable the analytics rule.
- End -