Specifications

SPEEDDOME ULTRA VII CAMERA DOME INSTALLATION AND SERVICE GUIDE (8200-0184-01, REV. A1)
12 of 41
Indoor Installation
This section explains how to connect the housing
and eyeball assembly to a:
· Standard mounting base
· Mounting base with I/O board.
Items You Will Need
You should have on hand the following
tools and parts:
GInstall/Removal tool to attach and detach domes
and bubbles without a ladder from mounting
bases with I/O boards.
GBase kit:
- RUIOB/RUWIOB (base with I/O board), or
- RUPTB/RUWPTB (standard base).
GHousing and eyeball assembly, 0101-0041-XX.
The -XX determines the type of camera used.
-01 = Color 22X NTSC (for dome with black finish)
-02 = Color 22X PAL (for dome with black finish)
-03 = BW 22X EIA (for dome with black finish)
-04 = BW 22X CCIR (for dome with black finish)
-05 = Color 22X NTSC (for dome with white finish)
-06 = Color 22X PAL (for dome with white finish)
-11 = Color 23X NTSC (for dome with black finish)
-12 = Color 23X PAL (for dome with black finish)
-15 = Color 23X NTSC (for dome with white finish)
-16 = Color 23X PAL (for dome with white finish)
Other Preparations
To ensure a smooth and successful
installation, you must:
· Have electrical work comply with latest national
electrical code, national fire code, and all
applicable local codes and ordinances.
· Coordinate work with other trades to avoid
interference.
· Verify existing site conditions and coordinate
with the owner's representative and appropriate
utilities as required.
· Obtain copies of all related plans, specifications,
shop drawings and addenda to schedule and
coordinate related work.
· Thoroughly review the project to ensure that all
work meets or exceeds the above requirements.
Bring alleged discrepancies to the attention of
the CCTV Project Coordinator.