Specifications

SPEEDDOME ULTRA VII CAMERA DOME INSTALLATION AND SERVICE GUIDE (8200-0184-01, REV. A1)
15 of 41
6. Connect the 4-pin plug (alarm input/output) to
the 4-pin receptacle (Figure 13).
a. Feed the cable through the access hole in
the base.
b. Connect alarm wires to the 4-pin plug (refer
to chart below).
c. Insert the plug into the mating receptacle in
the top of the housing and eyeball assembly.
Alarm connections
Pin Color Designation
1 —
+12Vdc
2 — Alarm Out
3 — Alarm In
4 — Common
Figure 13. Cable connections (Manchester
requires separate cables for data and power)
7. Connect the housing and eyeball assembly to
the base (Figure 14).
a. Align the dimple on the cap of the dome with
the rib on the mounting base.
b. Mate the housing and eyeball assembly to
the base and turn it clockwise until you hear
a click.
Figure 14. Connecting housing and eyeball
assembly to base (cables and lanyard not
shown)
L
A
T
C
H
8. Apply power and wait a few seconds for the
dome to begin its homing routine. The homing
routine indicates that address was placed into
dome memory and that dome is ready for
programming.
Note: If the homing routine does not occur or if
the dome does not respond to commands,
check the cable wiring by referring to the LED
response tables in Appendix A.
9-pin plug
LEDs CR2,
CR3, and CR4
visible through
opening.
4-pin plug