Specifications

SPEEDDOME ULTRA VII CAMERA DOME INSTALLATION AND SERVICE GUIDE (8200-0184-01, REV. A1)
22 of 41
Troubleshooting Indoor
Domes
CAUTION: This troubleshooting section is for
indoor camera domes only! To troubleshoot
outdoor domes, see installation and service
manual shipped with the outdoor housing.
This chapter contains information on:
· Routine troubleshooting
· Detailed troubleshooting
· Disassembling the dome.
IMPORTANT!
1. Try routine troubleshooting first! Use this
procedure to isolate the problem without
disassembling the housing and eyeball
assembly (the base with the I/O board is
field repairable).
CAUTION: DO NOT troubleshoot if the dome
functions but does not pan or tilt (see step 2).
2. If you cannot isolate the problem, or the dome
functions but does not pan or tilt, contact your
sales representative for repair instructions.
3. If you have no choice but to repair the housing
and eyeball assembly. Follow the detailed
troubleshooting procedure, but use extreme
care.
CAUTION: Once disassembled, parts of the
housing and eyeball assembly are "extremely
fragile" and may break. Proceed using extreme
care!
Items You Will Need
You should have on hand the following items:
· Phillips-head screwdriver
· Small slotted screwdriver
· 2.5mm (0.1") slotted screwdriver (for wire
connections). Wider blade widths can damage
connectors.
· Socket wrench with 5" extension and 5.5mm,
6mm, 8mm, and 10mm sockets
· 14-18 AWG and 20-22 AWG wire strippers
· Install/Removal tool to connect/disconnect
dome to indoor bases with I/O boards, and to
attach/detach skirts and bubbles—without a
ladder.