Specifications

SPEEDDOME ULTRA VII CAMERA DOME INSTALLATION AND SERVICE GUIDE (8200-0184-01, REV. A1)
32 of 41
6. Access tilt motor.
To do this, loosen captive retaining screw
holding tilt cable assembly in place and gently
remove this assembly.
7. Remove tilt motor (Figure 35).
Lift motor housing up as shown to disengage
motor from tilt gear. Then pull motor bracket
towards outside of cable/tilt assembly to remove
motor.
Figure 35. Removing the tilt motor
8. Reverse steps to reassemble.
CAUTION: When installing a new motor, be
careful to properly mesh motor and tilt gears!
Failure to do so can destroy both motor and tilt
gear. Verify tilt gear turns freely!
Tilt Motor
(Lift up, then out.)