Instruction Manual

Auto Ignition System

Part #BC2500

used on BabyC and Winchester units

• Turn off power on control panel and unplug from the power supply.

• Open up left side panel and find the ½” collar, locate on the igniter plug.

• Locate wire harness leads

for the igniter red lead and

white lead.

• Using 1/8” allen wrench loosen set screw from ½” collar located on the igniter

plug.

• Remove igniter plug pull towards

the back of the unit.

PAGE 1
Auto Ignition System Part #BC2500 used on BabyC and Winchester units • • Turn off power on control panel and unplug from the power supply. Open up left side panel and find the ½” collar, locate on the igniter plug. • Locate wire harness leads for the igniter red lead and white lead. • Using 1/8” allen wrench loosen set screw from ½” collar located on the igniter plug. • Remove igniter plug pull towards the back of the unit.
PAGE 2
• • Install igniter into collar where the igniter plug was. Position igniter so it slightly touches the firepot and the firepot can be removed. • • Connect igniter wires coming from the igniter to the wire harness using the white and red wires. • • Plug into power supply Turn power on control panel and restart. Tighten set screw attached to the ½” collar.