User Manual

12 VOLT

BATTERY

12 VOLT

SOLAR PANEL

NEG.

POS.

3 AMP / 50V DIODE

DRAFT SLIDE GATE ADJUSTMENT (Optional equipment)

The normal operation of the Magnum appliances would be with the

Draft Slide Gate open fully as shown (not standard on unit). When the gate is in the fully open position,

the plate will be against the mounting plate as shown. If the unit needs a draft correction adjustment, the

bolts are loosened and the slide gate is rotated a few degrees at a time until the proper operation of the

unit is achieved.

NOTE: This adjustment must be made by a qualified Magnum Service Tech.

When rotating the slide gate, be careful not to damage the gasket. Re-tighten the bolts and check for

leaks. The Draft Slide Gate is not shipped installed on the appliance. A qualified Magnum service Tech

would have to determine if this plate was needed. High altitude, high wind, high voltage and fuel quality

issues would be a few reasons for the need of the draft slide gate. Careful attention needs to be made to

not damaging the draft motor gasket when the gate is installed or adjusted. If the gasket is damaged you

must replace the gasket before operating the unit.

IGNITER REPLACEMENT

Draft Slide Gate

(optional)equipment

, not shipped with

unit. A service tech

will determine if

needed.

Exhaust Draft Motor

(AC model shown)

located inside of right

side panel

NOTE: Always

disconnect power

before making this

adjustment.

# 10 bolt with 5/16 hex head