Use and Care Manual

Push-Button Spark Ignition Kit

Use and Care Instructions

(AFG-INST-006_REVA_12/17)

The Push-Button Spark Ignition Kit is an alternative to traditional match lighting of an

outdoor fire feature. Once installed, the operator can simply press the ignition button

to produce sparks at the ignition probe tips to allow ignition of a fuel source (i.e. –

natural gas or propane).

Parts included: Necessary Tools:

● Push-Button Spark Generator ● Adjustable Wrench or Pliers

● Spark Igniter ● Screw Driver

● 36” Ground Lead

● Mounting Hardware (Screw, Flat Washer, and Nut)

Instructions:

1. Locate and remove blank mounting plate from burner pan by unscrewing stainless steel nuts and bolts.

2. Using the new mounting plate provided with your burner pan, insert the Spark Igniter Probe lead through the center

hole, aligning the outer holes with the Spark Igniter Probe mounting hole and ground post.

3. Insert the mounting screw through the mounting hole. From the bottom of the fire feature, attach the flat washer

terminal and tighten the nut beneath the flat washer terminal, securing the ground wire to the igniter base.

4. Attach both Spark Igniter Probe lead and ground wire lead to the back of the Push Button Spark Generator. Be sure

both of the available terminals are occupied. There is no specific order.

5. Mount the Push-Button Spark Generator to the outside of the fire feature with a custom mounting plate. We also

have a generic version of the mounting plate available for purchase.

6. To mount the Push Button Spark Generator our plate, start by removing rubber push button assembly and lock ring.

Insert the threaded portion of the battery cavity through the ¾” hole in the mounting plate, then use the locking ring

to secure the spark generator to the mounting plate. Finally, mount the plate and spark generator assembly to an

opening made in the enclosure wall.

7. Unscrew rubber push button assembly exposing the battery cavity. Insert ‘AAA” battery with negative side facing in.

Replace rubber push button.

American Fire Glass, Inc.

570 Third Street, Lake Elsinore, CA 92530

www.americanfireglass.com

1-888-264-1017

AFG-INST-006_REVA_12/17

PAGE 1
Push-Button Spark Ignition Kit Use and Care Instructions (AFG-INST-006_REVA_12/17) The Push-Button Spark Ignition Kit is an alternative to traditional match lighting of an outdoor fire feature. Once installed, the operator can simply press the ignition button to produce sparks at the ignition probe tips to allow ignition of a fuel source (i.e. – natural gas or propane).
PAGE 2
LIMITED LIFETIME CONSUMER PRODUCT WARRANTY The following warranty has been drafted to comply with the MAGNUSON-MOS-WARRANTY ACT applicable to products manufactured after July 4, 1975. It replaces and supersedes any warranty in this package or in any printed literature. LIMITED WARRANTY AMERICAN FIRE GLASS, 570 THIRD STREET, LAKE ELSINORE, CA U.S.A.