Use and Care Manual

ManualsBrandsAmerican Fire Glass ManualsAccessories24 in. Dual-Ring 304. Stainless Steel Fire Pit Ring Burner, 1/2 in. Inlet

Fire Pit Rings – (6”, 12”, 18”, 24”, 36”, 48”)

(AFG-INST-007_REVB_04/18)

In order to get just-the-right effect from your fire glass and flame display, you need to make sure that your flames

are realistic and distributed evenly. In order to achieve this, you need a high-quality Fire Pit Ring burner.

Our Fire Pit Rings fit on top of your fire pit burner pan. All Fire Pit Rings are made of high grade 304 stainless steel

which ensures their durability under extreme heat and severe weather conditions. The crossbar design provides

for better flame distribution. The holes in the rings are drilled, not punched, which prevents any loud whistling

noises. The Fire Pit Ring burner works best under 2 - 4 inches of fire glass.

Our Fire Pit Rings are available in several sizes and you should choose the size that is at least 6 inches smaller than

the internal dimensions of your fire pit. Installation is easy!

These instructions apply to American Fire Glass™ items:

Summary of content (6 pages)

PAGE 1
Fire Pit Rings – (6”, 12”, 18”, 24”, 36”, 48”) (AFG-INST-007_REVB_04/18) In order to get just-the-right effect from your fire glass and flame display, you need to make sure that your flames are realistic and distributed evenly. In order to achieve this, you need a high-quality Fire Pit Ring burner. Our Fire Pit Rings fit on top of your fire pit burner pan. All Fire Pit Rings are made of high grade 304 stainless steel which ensures their durability under extreme heat and severe weather conditions.
PAGE 2
CAUTION – DO NOT DISCARD THIS INSTRUCTION MANUAL • • • • Important Operating and Maintenance Instructions included. Read, understand, and follow these instructions for safe installation and operation. Leave this manual with party responsible for use and operation. Ensure proper drainage in fire feature to allow water to drain. Installation must comply with local codes, or, in the absence of local codes, must be compliant with the National Fuel Gas Code – ANSI Z223.1.
PAGE 3
Clearances Below is a general fire feature non-structure clearance guideline. Be sure to check for fire feature clearance guidelines, codes, or ordinances specifically for your area/region. WARNING – FIRE RISK ASSEMBLY Each Fire Pit Ring includes a center hub screw cap with wrench for installation. This screw cap provides the option to install the Fire Pit Ring with the gas exit holes facing up or down depending on the fuel type, region, and the type of fire feature the Fire Pit Ring is being used with.
PAGE 4
Start-up – A small amount of air will be in the gas supply lines. When first lighting the appliance it will take a short time for air to purge from lines. Subsequent lighting of the appliance will not require such purging. WARNING • • • Check for gas leaks after installation is complete. Check all fittings and connections Do not use open flame to check for leaks Check for leaks with a commercially available, non-corrosive leak check solution.
PAGE 5
CAUTION It is NOT recommended for outdoor fire appliances to be operated when wind exceeds 25 mph. Prior to turning appliance on, visually inspect to ensure debris such as leaves, or other combustible material has not collected inside the feature, as it could burn and emit embers when the appliance is turned on. Also, ensure any person standing close to the fire feature is aware you will be igniting the appliance on prior to turning it on. American Fire Glass, Inc.
PAGE 6
LIMITED LIFETIME CONSUMER PRODUCT WARRANTY The following warranty has been drafted to comply with the MAGNUSON-MOS-WARRANTY ACT applicable to products manufactured after July 4, 1975. It replaces and supersedes any warranty in this package or in any printed literature. LIMITED WARRANTY AMERICAN FIRE GLASS, 570 THIRD STREET, LAKE ELSINORE, CA U.S.A.