Use and Care Manual

ManualsBrandsAmerican Fire Glass ManualsAccessories36 in. Round Stainless Steel Flat Pan with Spark Ignition Kit - Propane (18 in. Ring Burner Included)

Flat Pan Spark Ignition Kits

Use and Care Instructions

(AFG-INST-020_REVB_04/18)

American Fire Glass™ Fire Pit Spark Ignition Flat Pan Kits offer time saving cost effective solutions of

internal components for natural gas and propane outdoor fire pits. These Flat Pan Kits are available in

square and round shapes of various sizes to accommodate different outdoor fire pit dimensions.

Kit Includes:

1. Stainless Steel Flat Pan (Square or Round)

2. Stainless Steel Fire Pit Ring

3. Fire Pit Connection Kit w/ Key Valve

4. Push-Button Igniter Kit

5. Propane Air Mixer (Propane Kits only)

6. Stainless Steel Control Plate (Optional)

IMPORTANT

Be sure to use gas thread seal for ALL non-tapered connections.

Be sure to tighten ALL connections securely.

The Flan Pan Assembly can be installed in various configurations, as determined by the installer. In some

instances, the flat pan is installed using hard pipe, and is supported by “filler” aggregate underneath the

flat pan. Some install the flat pan in a “sandwiched” method or on top of a “step” as part of the fire pit

structure.

American Fire Glass™ always recommends the components be installed by a licensed professional, and

in accordance with Federal, State, and local regulations such as ANSI Z21.97-2012 and CSA 2.41-2012.

Summary of content (5 pages)

PAGE 1
Flat Pan Spark Ignition Kits Use and Care Instructions (AFG-INST-020_REVB_04/18) American Fire Glass™ Fire Pit Spark Ignition Flat Pan Kits offer time saving cost effective solutions of internal components for natural gas and propane outdoor fire pits. These Flat Pan Kits are available in square and round shapes of various sizes to accommodate different outdoor fire pit dimensions. Kit Includes: 1. Stainless Steel Flat Pan (Square or Round) 2. Stainless Steel Fire Pit Ring 3.
PAGE 2
Fire Pit Pan Spark Ignition Kit Assembly Instructions (Cont.) Assembly Instructions STEP 1 - Install Fire Pit Ring plug into the top of the fire pit ring. Gas exit holes can be facing up or down. (FIGURE 1) Tip! Some prefer holes up for propane and holes down for natural gas. 1. STEP 2 - Screw fire pit ring onto the Flat Pan. (FIGURE 2) FIGURE 1 FIGURE 2 STEP 3 - Insert the Spark Igniter Probe into the Flat Pan, and secure with the provided screw and nut.
PAGE 3
STEP 6 - Attach the Igniter Spark Probe Wire and the Igniter Ground Wire to the back of the Push Button Assy. Either wire can be placed on either pin. Connect the eyelet end of the ground wire to a clean metal ground surface. (FIGURE 7) NOTE: The location and mounting of the control plate is to be determined by the installer. FIGURE 6 STEP 7 - Unscrew the Push Button rubber cap and be sure that the AAA battery is installed with the “-“ side facing the rubber button.
PAGE 4
American Fire Glass™, Inc. 570 Third Street, Lake Elsinore, CA 92530 www.americanfireglass.
PAGE 5
LIMITED LIFETIME CONSUMER PRODUCT WARRANTY The following warranty has been drafted to comply with the MAGNUSON-MOS-WARRANTY ACT applicable to products manufactured after July 4, 1975. It replaces and supersedes any warranty in this package or in any printed literature. LIMITED WARRANTY AMERICAN FIRE GLASS™, 570 THIRD STREET, LAKE ELSINORE, CA U.S.A.