Installation Instructions

VTR-P Series Undercabinet Fluorescent Fixture
Model 15
8060482 R0
Page 1
Safety Precautions
Read all safety precautions and installation instructions carefully before
installing or servicing this fixture. Failure to comply with these
instructions could result in potentially fatal electric shock and/or
property damage.
It is recommended that all wiring be performed by a qualified
electrician. This fixture must be wired in accordance with all national
and local electrical codes.
Do not handle any energized fixture or attempt to energize any fixture
with wet hands or while standing on a wet or damp surface or in water.
This fixture is designed for use in a 110-120VAC, 60Hz fused circuit.
Do not use on a dimming circuit.
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground connection
of your main power supply panel. The green ground screw location is
clearly marked on the fixture housing.
This fixture is intended for use in dry locations.
ASSEMBLY INSTRUCTIONS
1. Preparing for installation
A. Remove fixture from carton.
B. Remove the diffuser by pulling back on the arrows at each end.
C. Remove the bulb from the fixture by rotating it until the pins disengage from the sockets. Remove the cardboard support from the
lamp.
2.
Fixture mounting
A. There are two sets of mounting holes on this fixture. One is located on the top side and the other is on the back side. If using top
side keyholes, hold channel (1) up to the undercabinet surface. Mark the locations of the narrow end of the keyslot holes on the
undercabinet. If using back side keyholes, mark locations for holes on the wall 13 3/16” apart from one another.
B. Drill a small pilot hole at your marked locations.
C. Install ½” wood screws (2) into cabinet and leave a ⅛” gap.
Caution-Injury to persons and damage to the lamp and/or mounting surface may result if the lamp is pulled from the surface. To
reduce the likelihood of such injury or damage, mount only on a surface that is structurally sound.
D. Place the channel flush against the undercabinet with the screws passing through the large ends of the keyholes, then slide it over
into the smaller slots.
E. Secure channel to the cabinet by tightening screws, no additional screwing is necessary if wall mounted.
F. Reinstall lamp by inserting pins into lamp holder. Rotate into place to seat lamp for proper connection.
G. Install plastic lens unto the fixture.
H. Plug cord into receptacle.
3. Bulb Replacement
For a bulb replacement use a F15T8 lamp
Limited Factory Warranty
American Fluorescent Corporation hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal
operating conditions for a period of 2 years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or
components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.