Installation Instructions
9
Hydro Massage Products LLC • 303-341-1845 | FAX: 303-341-1850 • www.hydromassageproducts.com • service@hydromassageproducts.com
Most parts involved in tail piece installation are provided by the
installer.
10. Hydro Massage Products will provide a 1.5" pt x 1.5" slip
PVC adapter to connect drain body to P-Trap.
11. Apply a small bead of RTV silicone to threads of drain body
and screw on PVC adapter. Hand tighten only, being sure
not to twist drain body in tub.
12. Use whatever PVC ttings and pipe as necessary (provided
by installer) to plumb PVC adapter to P-trap.
INSTALL BATHTUB
NOTE: Remote blower installations continue on pages 12
then return to step 13
13. Apply a generous bead of adhesive or silicone to the bottom
of the tub supports (gure 6).
14. Then apply a bead of tub and tile caulk around the edge of
the base (gure 6).
15. Carefully set tub into position (gure 7) and connect the
drain hardware (previously installed). Finish the installation
of the tail-piece.
COMPLETE BATHTUB INSTALLATION
16. Fill the tub with water to the overow and allow to set for
20 minutes, then drain the tub while inspecting the waste
connections below the oor for leaks. Access from below
will be necessary for this step (gure 8).
17. With the tub now in place, wipe off any excess tub and tile
caulk and adhesive where the tub meets the oor.
18. Run a bead of tub and tile caulk around the bottom edge of
the tub where it meets the oor. Wipe off any excess caulk
with a wet cloth (gure 9)
INSTALL OVERFLOW HARDWARE
19. Place the Back Plate over the screw of the Overow Cover
(gure 10)
20. Then align the Overow Cover with the bar (installed at the
factory in the overow hole (gure 11).
21. Carefully hand tighten the Overow Cover until it stops. DO
NOT OVER TIGHTEN.
INSTALLATION WITHOUT ACCESS TO BOTTOM OF UNIT
FREESTANDING INSTALLATION INSTRUCTIONS
for Oasis
Rubber drain
gasket