Use and Care Manual

ManualsBrandsAmerican Heritage Billiards ManualsAir Hockey TablesElement Air Hockey Table in Stone

#390027

FOOSBALL TABLE

ELEMENT

Do you have a question concerning your American Heritage Billiards product? Pleasecontct the retailer you purchased

your furniture from to get more information on he product. lf you cannot contact the retaileryou purchased from,please

send us an inquiry to our website and we’’ll do best to help.Thank you for your support!

Summary of content (8 pages)

PAGE 1
ELEMENT FOOSBALL TABLE #390027 Do you have a question concerning your American Heritage Billiards product? Pleasecontct the retailer you purchased your furniture from to get more information on he product. lf you cannot contact the retaileryou purchased from,please send us an inquiry to our website and we’’ll do best to help.
PAGE 2
Congratulations! We hope you will have many hours of enjoyable use with your new AHB Foosball Table! PLEASE KEEP YOUR INSTRUCTIONS! • Your Model number is necessary should you need to contact us. • Please read through this instruction book to familiarize yourself with all the parts and assembly steps. • Refer to parts ldentifier and verify that all parts have been included. WARNING! This is not a child’s toy. Adult supervision is required for children playing this game. Please read instructions carefully.
PAGE 3
PAGE 4
STEP 1: SET THE CARTON ON A FLAT WORK AREA WITH FREE SPACE. REMOVE PLAYFIELD TRIM (#5) FROM THE CARTON AND SAVE FOR LATER STEP. REMOVE THE “X” LEG (#2) AND CROSS BAR (#3) FROM THE CARTON. UNSCREW THE WASHER AND NUTS FROM THE CROSS BAR (#3) AND ASSEMBLE WITH THE “X” LEG ACCORDING TO FIGURE 1 BY HAND TIGHTENING THE WASHER AND NUTS Fig 1 .
PAGE 5
STEP 2: SET TWO FEET (#4) ON THE FLOOR AS SHOWN IN FIGURE 2. ATTACH THE “X” LEG TO THE FOOT USING WASHER (#10) AND BOLT (#9). DO NOT COMPLETELY TIGHTEN ANY BOLTS UNTIL ALL HAVE BEEN INSERTED. COMPLETELY. USING WRENCH (#8), TIGHTEN EACH BOLT Fig 2 STEP 3: REMOVE THE MAIN CABINET (#1) FROM THE CARTON AND PLACE ON A FLAT WORK AREA UPSIDE DOWN. ATTACH THE “X” LEG TOTHE MAIN CABINET USING WASHER (#10) AND BOLT (#9). DO NOT COMPLETELY TIGHTEN ANY BOLTS UNTIL ALL HAVE BEEN INSERTED.
PAGE 6
STEP 4: ATTACH THE PLAYFIELD TRIM (#5) TO THE LONG SIDE EDGE OF THE PLAYFIELD. ENSURE THAT THE PLAYFIELD TRIM IS FLUSH TO THE WALL .
PAGE 7
STEP 5: PLACE THE ROD (#17) THROUGH THE HOLE ON THE TABLE AND ARRANGE THE PARTS ACCORDING TO FIGURE 5 CLOSE UP. FIRST PLACE THE BUMPER (#13). THEN PLACE THE WASHER (#12) THEN PLACE THE APPROPRIATE AMOUNT OF PLAYERS (#14 OR #15). THEN PLACE THE WASHER (#12). THEN PLACE THE BUMPER (#13). THEN ATTACH THE ROD END CAP (#11) OR HANDLE (#21) TO THE CORRECT SIDE OF THE ROD. ATTACH THE PLAYERS USING THE SCREW(#19) AND NUT (#20) ATTACH THE HANDLE (#21) WITH THE SCREW (#22).
PAGE 8
STEP 6: ATTACH THE SCORING SYSTEM (#6) TO BOTH ENDS OF THE CABINET USING SCREW (#23) AND ALLEN KEY (#7). PLACE THE WOODEN SCREW CAP (#26) ON THE SCORING SYSTEM.