Jlmeri1an International Car Stereo Installation Kits &Accessories ...·-=--:: en c c ·-.... a= :IS VEHICLE APPLICATIONS KIA 2001-05 2001-05 2002-05 1999-02 2000-03 1998-02 OPTIMA RIO SEDONA SEPHIA SPECTRA SPORTAGE ©2009 AMERICAN INTERNATIONAL INDUSTRIES. INC . = 11111N .... •:IIIII Ver.
For 2002·03 Spectra Kit Assembly instructions see page 5 1999·02 Kia Sephia 2000·03 Kia Spectra DASH DISASSEMBLY 1. 2. 3. 4. 5. 6. 7. Remove the (2) Phillips screws above the instrument panel gauges. Remove the (3) Phillips screws from the bottom side of the steering wheel column. Carefully remove the steering column cover. Carefully unsnap the Radio/ instrument cluster trim panel. Disconnect all harnesses from the instrument trim panel, and remove the trim panel.
ISO MOUNT ASSEMBLY INSTRUCTIONS ISO MOUNT RADIOS ONLY 1. Remove mounting tabs from both sides of ISO mount brackets for these vehicle applications. 2. Insert shift spacers into ISO mount brackets (see Figure A). 3. Attach left and right ISO mounting brackets to main bracket. 4. Install ISO trim ring into main bracket. 5. Install radio into kit using screws supplied with radio (do not tighten screws at this time). 6. Adjust radio forward or backward for best look. 7. Tighten screws after adjusting radio.
6. Remove the (2) upper 5/16 plastic bolts from this panel, and loosen the (2) lower plastic bolts to allow access to the ( 1) phillips screw securing the left sidepanel (with pocket). Remove this (1) Phillips screw and remove the side trim panel. 7. Remove the ( 1) Phillips screw from under the edge of the dash below the dimmer control. 8. Remove the (3) Phillips screws from the bottom of the steering column cover, and remove the top and bottom covers. 9.
LEFT BRACKET ~?: {~ .,. . l::'' - - - - - L~ CUT OR TRIM PLASTIC 5/16" INWARD FROM THE OUTER EDGE OF THE LOWER MOUNTING TABS AS ILLUSTRATED ON BOTH LEFT AND RIGHT MOUNTING BRACKETS SHOWN IN FIGURE B P,lg,~\: ' (:e;, -~ _· ~~~ -:ar _ ISO Mount Spacers j ,:)\ Remove Rear fig. A , ':;!~mounting tabs -- RIGHT BRACKET on left & right brackets for 2002-03 Spectra Fig.
ISO MOUNT ASSEMBLY INSTRUCTIONS ISO MOUNT RADIOS ONLY 1. Insert shaft spacers into ISO mount brackets (see Figure B). 2. Attach left and right ISO mounting brackets to main bracket. 3. Install ISO trim ring into main bracket. 4. Install radio into kit using screws supplied with radio (do not tighten screws at this time). 5. Adjust radio forward or backward for best look. 6. Tighten screws after adjusting radio. Fig.
2002·05 Kia Sedona DASH DISASSEMBLY 1. 2. 3. 4. 5. 6. 7. 8. 9. Set the emergency brake. Open the ashtray lid and remove the ash cup. Remove the (1) Phillips screw from under the ash cup location. Carefully unsnap the ashtray assembly I dash trim bezel , disconnect all harnesses from the ashtray I lighter assembly and remove the trim. Remove the (4) Phillips screws securing the climate control panel to the sub-dash.
For information about other American International automotive accessories visit our we~ite at: .! http://www.americanlnternational.
